HuaWei StartCode 2012.02 (R13C10 Apr 22 2014 – 18:06:02)
NAND: Nand(Hardware): 128 MiB
startcode select the uboot to load
the high RAM is :8080103c
startcode uboot boot count:0
Slave struct initializtion success!!
Use the UbootA to load first
Start from UbootA ERROR, Change to UbootB
Both UbootA and UbootB are wrong, load it by JTAG!
U-Boot 2010.03 (R16C10 Jul 14 2019 – 14:19:37)
DRAM: 128 MB
Boot From NAND flash
Chip Type is SD5115T
NAND: Special Nand id table Version 1.23
Nand ID: 0x01 0xF1 0x00 0x1D 0x01 0xF1 0x00 0x1D
ECC Match pagesize:2K, oobzie:64, ecctype:4bit
Nand(Hardware): Block:128KB Page:2KB Chip:128MB*1 OOB:64B ECC:4bit
128 MiB
Using default environment
In: serial
Out: serial
Err: serial
PHY power down !!!
[main.c__6080]::CRC:0x39e1f1