rip路由协议计算机网络实验报告,RIP 动态路由协议的配置(实验报告).doc

学 生 实 训 报 告

实训课名称________ 计 算 机 网 络_______

实训内容 RIP 动态路由协议的配置

学 院 数信学院 年级 050711

专 业 数学与应用数学

学 生 姓 名___ 杨义_ 学 号__ 13 _

开 课 时 间_ 2007__ 至 _ 2008_ 学年第_ 一_学期

RIP 动态路由协议的配置

实训环境与网络拓扑结构图

①实训模拟器材：2台PC和3台2500路由器

②拓扑结构图:

2. 实训内容

配置路由器R1、R2和R3的各个接口的IP地址，在每个路由器上配置RIP路由协议，然后测试R1到R3的连通性。

3.实训步骤

①配置路由器各个接口的IP地址

路由器R1的配置:

Press Enter to Start

Router>

Router>en

Router#conf t

Enter configuration commands, one per line. End with CNTL/Z.

Router(config)#hostname R1

R1(config)#interface E0

R1(config-if)#ip address 192.168.1.1 255.255.255.0

R1(config-if)#no shut

%LINK-3-UPDOWN: Interface Ethernet0, changed state to up

R1(config-if)#exit

R1(config)#interface S0

R1(config-if)#ip address 192.168.2.1 255.255.255.0

R1(config-if)#clock rate 6400

R1(config-if)#no shut

%LINK-3-UPDOWN: Interface Serial0, changed state to up

%LINK-3-UPDOWN: Interface Serial0, changed state to down

%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0, changed state to down

R1(config-if)#exit

R1(config)#exit

R1#write memory

Building configuration...

[OK]

R1#copy running-config startup-config

Destination filename [startup-config]?

Building configuration...

[OK]

路由器R2的配置:

Press Enter to Start

Router>en

Router#conf t

Enter configuration commands, one per line. End with CNTL/Z.

Router(config)#hostname R2

R2(config)#interface S1

R2(config-if)#ip address 192.168.2.2 255.255.255.0

R2(config-if)#clock rate 6400

R2(config-if)#no shut

%LINK-3-UPDOWN: Interface Serial1, changed state to up

R2(config-if)#exit

R2(config)#interface S0

R2(config-if)#ip address 192.168.3.1 255.255.255.0

R2(config-if)#clock rate 6400

R2(config-if)#no shut

%LINK-3-UPDOWN: Interface Serial0, changed state to up

%LINK-3-UPDOWN: Interface Serial0, changed state to down

%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0, changed state to down

R2(config-if)#exit

R2(config)#exit

R2#write memory

Building configuration...

[OK]

R2#copy running-config st