电脑没网络显示服务器错误怎么办,电脑上不去网怎么办？别着急，我来帮您！（宽带错误提示大全）...

该楼层疑似违规已被系统折叠 隐藏此楼查看此楼

692 Hardware failure in port or attached device. 端口或者附属设备的硬件有故障。 693 ERROR NOT BINARY MACRO 错误提示：没有二进制的宏。 694 ERROR DCB NOT FOUND 错误提示：DCB没有被发现。 695 ERROR STATE MACHINES NOT STARTED 错误提示：机器设备没有被启动。 696 ERROR STATE MACHINES ALREADY STARTED 错误提示：机器设备已经被启动。 697 ERROR PARTIAL RESPONSE LOOPING 错误提示：部分循环响应错误。 698 A response keyname in the device .INF file is not in the expected format. 驱动器INI文件中的响应关键字不是标准的格式。 699 The device response caused buffer overflow. 驱动器响应导致缓冲器溢出。 700 The expanded command in the device .INF file is too long. 在驱动器的INI文件中的扩展命令太长。 701 The device moved to a BPS rate not supported by the COM driver. 驱动器改变的BPS速率不被COM口支持。 702 Device response received when none expected. 以外的收到设备响应。 703 ERROR INTERACTIVE MODE 错误提示：交互模式。 704 ERROR BAD CALLBACK NUMBER 错误提示：不可用的回叫号码。 705 ERROR INVALID AUTH STATE 错误提示：无效的AUTH状态。 706 ERROR WRITING INITBPS 错误提示: 初始化BPS错误。 707 X.25 diagnostic indication. X—25诊断指示。 708 The account has expired. 该帐号已经被拒绝。 709 Error changing password on domain. 密码改变错误。 710 Serial overrun errors were detected while communicating with your modem. 但使用你的MODEM通讯时，串行超限错误被侦测。 711 RasMan initialization failure. Check the event log. RasMan 初始化失败。请检查事件记录。 712 Biplex port is initializing. Wait a few seconds and redial. Biplex 端口正在初始化。等一会儿再拔号。 713 No active ISDN lines are available. 非活动有ISDN线路可用。 714 Not enough ISDN channels are available to make the call. 半速动行的ISDN通道对电话呼叫来说是有效的。 715 Too many errors occurred because of poor phone line quality. 电话线路低略造成太多的错误。 716 The Remote Access IP configuration is unusable. 远程访问IP配置不可用。 717 No IP addresses are available in the static pool of Remote Access IP addresses. 对于静态的远程访问IP地址库来说没有IP地址也是可用的。 718 PPP timeout. PPP(Peer-Peer-Protocol)点对点协议通讯超时。 719 PPP terminated by remote machine. PPP通讯被远程设备终止。 720 No PPP control protocols configured. 没有PPP控制协议被配置。 721 Remote PPP peer is not responding. 远程PPP设备没有应答。 722 The PPP packet is invalid. 该PPP数据包是无效的。 723 The phone number, including prefix and suffix, is too long. 电话号码(包括电话区号和分机号)太长。 724 The IPX protocol cannot dial-out on the port because the computer is an IPX router. 因为这台计算机是IPX路由器，所以IPX协议在该端口不能被发送。 725 The IPX protocol cannot dial-in on the port because the IPX router is not installed. 因为IPX路由器没有安装，所以IPX协议不能在该端口被接收。 726 The IPX protocol cannot be used for dial-out on more than one port at a time. IPX协议在同一时间里只能由一个端口发送。 727 Cannot access TCPCFG.DLL. 不能打开 TCPCFG.DLL文件。 728 Cannot find an IP adapter bound to Remote Access. 没有找到用于远程访问的IP适配器。 729 SLIP cannot be used unless the IP protocol is installed. 除非IP协议被安装，才能使用SLIP。 730 Computer registration is not complete. 计算机注册没有完成。 731 The protocol is not configured. 通讯协议没有被配置。 732 The PPP negotiation is not converging. PPP数据流不能被收集。 733 The PPP control protocol for this network protocol is not available on the server. 在该服务器上PPP控制协议对于整个网络协议是不可用的。 734 The PPP link control protocol terminated. PPP链接控制协议被终止。 735 The requested address was rejected by the server. 请求的地址被服务器弹出。 736 The remote computer terminated the control protocol. 远程计算机终止了控制协议。 737 Loopback detected. Loopback 被检测。 738 The server did not assign an address. 该服务器没有分配一个地址。 739 The remote server cannot use the Windows NT encrypted password. 远程服务器不能使用WIN NT 加密密码。 740 The TAPI devices configured for Remote Access failed to initialize or were not installed correctly. 用于远程访问有TAPI设备初始化失败或没有被正确安装。 741 The local computer does not support encryption. 本地计算机不支持加密。 742 The remote server does not support encryption. 远程服务器不支持加密。