linux eth 注册,linux修改eth#

有的时候当你用RAID从其他机器克隆一个系统到新硬盘中时，会出现新网卡不是从eth0开始，如果你想修改网卡从eth0开始，可以编辑"/etc/udev/rules.d/70-persistent-net.rules",如下

HostA:/dev # vi /etc/udev/rules.d/70-persistent-net.rules

# This file was automatically generated by the /lib/udev/write_net_rules

# program run by the persistent-net-generator.rules rules file.

#

# You can modify it, as long as you keep each rule on a single line.

# PCI device 0x15ad:0x07b0 (vmxnet3)

SUBSYSTEM=="net", ACTION=="add", DRIVERS=="?*", ATTR{address}=="00:50:56:a2:00:71", ATTR{type}=="1", KERNEL=="eth*", NAME="eth1"

把eth1，改为eth0,保存后重启。

重启后发现机器ping不通，想办法连接到console，ifconfig发现无eth1

lo        Link encap:Local Loopback

inet addr:127.0.0.1  Mask:255.0.0.0

inet6 addr: ::1/128 Scope:Host

UP LOOPBACK RUNNING  MTU:16436  Metric:1

RX packets:98 errors:0 dropped:0 overruns:0 frame:0

TX packets:98 errors:0 dropped:0 overruns:0 carrier:0

collisions:0 txqueuelen:0

RX bytes:9059 (8.8 Kb)  TX bytes:9059 (8.8 Kb)

原来刚才修改完文件后并未修改eth config文件。

HostA:~ # cd /etc/sysconfig/network/

HostA:/etc/sysconfig/network # mv ifcfg-eth1 ifcfg-eth0

HostA:/etc/sysconfig/network # /etc/init.d/network restart

eth0      Link encap:Ethernet  HWaddr 00:50:56:A2:00:71

inet addr:192.168.1.x  Bcast:192.168.1.255 Mask:255.255.255.0

inet6 addr: fe80::250:56ff:fea2:71/64 Scope:Link

UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1

RX packets:5576 errors:0 dropped:0 overruns:0 frame:0

TX packets:553 errors:0 dropped:0 overruns:0 carrier:0

collisions:0 txqueuelen:1000

RX bytes:501494 (489.7 Kb)  TX bytes:204124 (199.3 Kb)

OK,网络设定已经完成，但是发现还是无法ping通该主机，但是可以从主机内ping通网关。原来还需要修改routes

HostA:/etc/sysconfig/network # vi routes

default 192.168.1.254 - eth1

把eth1修改为eth0。保存，重启网络服务，ping通，搞定,收工