Loader¶
In Loader mode, the bootloader will enter into upgrade status to wait for the command of the host, which is mainly used for firmware upgrade and etc.
To enter into Loader mode, you need to ensure that the bootloader can detect the RECOVERY is pressed and the USB is connected.
There are two ways to enter into the Loader mode:
One way, Disconnect the power adapter and the Micro USB OTG cable from the device:
Connect one end of the Micro USB OTG cable to the host.
Press the RECOVERY button on the device and hold the button.
Connect the other end of the Micro USB OTG cable to the device.
Wait for about 2 seconds and release the RECOVERY button.
Othor way, you don’t need to disconnect the power adapter and the Micro USB OTG cable from the device:
Connect the device and the host with the Micro USB OTG cable.
Press the RECOVERY button on the device and hold the button.
Short press the RESET button.
Wait for about 2 seconds and release the RECOVERY button.