arm linux 串口调试,linux使用usb转串口调试ARM开发板

usb转串口使用的是pl2303芯片，linux2.4以上版本已经自带驱动。

1.安装minicom

Ubuntu中使用 sudo apt-get install minicom 安装即可

2.配置minicom

# minicom -s

Serial port setup [Enter]

+-------------------------------------------------------------+

| A -    Serial Device      : /dev/ttyUSB0                    |

| B - Lockfile Location     : /var/lock                       |

| C -   Callin Program      :                                 |

| D - Callout Program      -:                                 |

| E -    Bps/Par/Bits       : 115200 8N1                      |

| F - Hardware Flow Control : No                              |

| G - Software Flow Control : No                              |

|                                                             |

|    Change which setting?                                    |

+-------------------------------------------------------------+

注: 如果没有使用USB转接口，Serial Device要配置为/dev/ttyS0

Save setup as dfl

Exit from Minicom

使用USB转串口需要注意：

首先要加载USB-serial转换线驱动：modprobe pl2303

查看状态：dmesg | grep pl2303

[ 2788.401258] usb 6-1: FTDI USB Serial Device converter now attached to ttyUSB0

[ 6664.718291] usbcore: registered new interface driver pl2303

3.使用minicom传输文件

--------------------------------------------------

# minicom

(Ctrl + a) --> s --> zmodem --> [Okay] -->

+-----------------------------------------+

|No file selected - enter filename:       |

|> /home/zxl/ssl/codes/led/lls_led.ko     | [Enter]

+-----------------------------------------+