单片机按键控制数码管c语言程序,基于单片机的,用C怎么编程,让没按一下按键,数码管自动加一。另外一个按键没按一下,数码管自动减一。...

刚刚写的。没做仿真。你试哈，有问题在改

#include //包含头文件，一般情况不需要改动，头文件包含特殊功能寄存器的定义

#define uint unsigned int

#define uchar unsigned char

sbit key1=P3^0; //定义按键位置

sbit duan=p2^6;

sbit duan=p2^7;

uchar code table[]={

0x3f,0x06,0x5b,0x4f,

0x66,0x6d,0x7d,0x07,

0x7f,0x6f,0x77,0x7c,

0x39,0x5e,0x79,0x71};

uint shu;

/*------------------------------------------------

延时子程序

------------------------------------------------*/

void delay(unsigned int cnt)

{

while(--cnt);

}

void display(uchar shu);

/*------------------------------------------------

主函数

------------------------------------------------*/

main()

{

shu=99;

while(1)

{

if(!key1)

{ //按下相应的按键，数码管显示相应的码值

delay(1000);

if(!key1)

{

shu--;

dispaly(shu);

if(shu==0)

{

shu=99;

}

}

}

}

}void display(uchar shu)

{

uchar shi;

uchar ge

shi=shu/10;

ge=temp%10;

dula=1;

P0=table[shi];

dula=0;

P0=0xff;

wela=1;

P0=0xfd;

wela=0;

delay(1);

dula=1;

P0=table[ge];

dula=0;

P0=0xff;

wela=1;

P0=0xfb;

wela=0;

delay(1);

}

取消

评论