c语言烧写软件,adi 程序烧写

3.2 U-Boot Console Output

Here we need set up minicom to open target board serial console.

sudo minicom -s

choose “Serial port setup”

set “Serial Device” to /dev/ttyUSB0

set “Bps/Par/Bits” to 57600 8N1

set “Hardware Flow Control” to No.

choose "Save setup as dfl"

choose "Exit"

After setting up like above, it can open one terminal on Ubuntu. Next time you can run directly:

sudo minicom

This command would open the console for your U-Boot.

Note: if you are working from virtual machine and want to use the serial console from it, you will also need to pass-through related serial device to your VM.