计算机外文翻译旅游网站,外文翻译--旅游路线及管理系统（适用于毕业论文外文翻译+中英文对照）.doc...

w

毕业设计(论文)外文参考文献翻译

计算机科学与信息工程 系(院)届

题 目(中文) 旅游路线及管理系统

(英文) travel routes and management system

学生姓名

学号

专业班

完成日期： 年 月 日

目 录

外 文 原 文(一 )

Electric circuit exchange network

and vb transfer database

The result of the connection setup with circuit switching is the reservation of bandwidth all the way from the sender to the receiver. All packets follow this path. Among other properties, having all packets follow the same path means that they cannot arrive out of order. With packet switching there is no path , so different packets can follow different paths, depending on network conditions at the time they are sent. They may arrive out of order.

Packet switching is more fault tolerant than circuit switching. In fact, that is why it was invented. If a switch goes down, all of the circuits using it are terminated and no more traffic can be sent on any of them. With Packet switching, packets can be routed around dead switches.

Setting up a path in advance also opens up the possibility of reserving bandwidth in advance. If bandwidth is reserved, then when a packet arrives, it can be sent out immediately over the reserved bandwidth. With packet switching, no bandwidth is reserved, so packets may have to wait their turn to be forwarded.

Having bandwidth reserved in advance means that no congestion can occur when a packet shows up (unless more packets show up than expected).On the other hand, when an attempt is made to establish a circuit, the attempt can fail due to congestion. Thus, congestion can occur at different times with circuit switching(at setup time) and packet switching(when packets are sent).

If a circuit has been reserved for a particular user and there is no traffic to send, the bandwidth of that circuit is wasted. It cannot be used for other traffic. Packet switching does not waste bandwidth and thus is more efficient form a system-wide perspective. Understanding this trade-off is crucial for