linux查看软件流量,linux 查看网络实时流量工具（nload）

使用nload工具可以实时查看网络流量 nload -u M -m

官网及下载

安装wget http://www.roland-riegel.de/nload/nload-0.7.2.tar.gz

tar zxvf nload-0.7.2.tar.gz

cd nload-0.7.2

./configure;make;make install

使用

直接用nload回车即可,也可以指定网卡,如nload eth1

还可以指定是以K或M来显示流量,如nload -u M显示的流量是以MB为单位的

看看还有哪些参数或选项Command line syntax:

nload [options] [devices]

nload --help|-h

Options:

-a period       Sets the length in seconds of the time window for average

calculation.

Default is 300.

-i max_scaling  Specifies the 100% mark in kBit/s of the graph indicating the

incoming bandwidth usage. Ignored if max_scaling is 0 or the

switch -m is given.

Default is 10240.

-m              Show multiple devices at a time; no traffic graphs.

-o max_scaling  Same as -i but for the graph indicating the outgoing bandwidth

usage.

Default is 10240.

-t interval     Determines the refresh interval of the display in milliseconds.

Default is 500.

-u h|b|k|m|g    Sets the type of unit used for the display of traffic numbers.

H|B|K|M|G    h: auto, b: Bit/s, k: kBit/s, m: MBit/s etc.

H: auto, B: Byte/s, K: kByte/s, M: MByte/s etc.

Default is h.

-U h|b|k|m|g    Same as -u, but for a total amount of data (without "/s").

H|B|K|M|G    Default is H.

devices         Network devices to use.

Default is to use all auto-detected devices.

--help

-h              Print this help.

example: nload -t 200 -i 1024 -o 128 -U M