[root@localhost ~]# ip add
1: lo: mtu 16436 qdisc noqueue state UNKNOWN
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
inet 127.0.0.1/8 scope host lo
inet6 ::1/128 scope host
valid_lft forever preferred_lft forever
2: eth0: mtu 1500 qdisc pfifo_fast state UP qlen 1000
link/ether 08:9e:01:dc:4b:ce brd ff:ff:ff:ff:ff:ff
inet 58.63.235.42/25 brd 58.63.235.127 scope global eth0
inet6 fe80::a9e:1ff:fedc:4bce/64 scope link
valid_lft forever preferred_lft forever
3: eth1: mtu 1500 qdisc pfifo_fast state UP qlen 1000
link/ether 08:9e:01:dc:4b:cf brd ff:ff:ff:ff:ff:ff
inet 10.71.3.42/24 brd 10.71.3.255 scope global eth1
inet6 fe80::a9e:1ff:fedc:4bcf/64 scope link
valid_lft forever preferred_lft forever
4: eth2: mtu 1500 qdisc noop state DOWN qlen 1000
link/ether 08:9e:01:dc:4b:d0 brd ff:ff:ff:ff:ff:ff
5: eth3: mtu 1500 qdisc noop state DOWN qlen 1000
link/ether 08:9e:01:dc:4b:d1 brd ff:ff:ff:ff:ff:ff
[root@localhost ~]# lspci |grep Eth
02:00.0 Ethernet controller: Intel Corporation Device 1557 (rev 01)
04:00.0 Ethernet controller: Intel Corporation 82574L Gigabit Network Connection
05:00.0 Ethernet controller: Intel Corporation 82574L Gigabit Network Connection
06:00.0 Ethernet controller: Intel Corporation 82574L Gigabit Network Connection
07:00.0 Ethernet controller: Intel Corporation 82574L Gigabit Network Connection
[root@localhost ~]# ethtool -i eth1
driver: e1000e
version: 2.5.4-NAPI
firmware-version: 2.1-3
bus-info: 0000:05:00.0
[root@localhost ~]# ethtool eth1
Settings for eth1:
Supported ports: [ TP ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Advertised pause frame use: No
Advertised auto-negotiation: Yes
Speed: 1000Mb/s
Duplex: Full
Port: Twisted Pair
PHYAD: 1
Transceiver: internal
Auto-negotiation: on
MDI-X: on
Supports Wake-on: pumbg
Wake-on: g
Current message level: 0x00000007 (7)
Link detected: yes