Circuit design of SMD aluminum electrolytic capacitor

Circuit design of SMD aluminum electrolytic capacitor

(1) Ensure that the capacitors are used and installed in the product catalog.
(2) The operating temperature and applied ripple current shall be within the limits specified in the company's product catalog.
1 Do not use at temperatures exceeding the maximum operating temperature.
2 Do not turn on the maximum allowable rated ripple current.
(3) When designing the circuit, select the product that meets the life requirements.
(4) SMD type aluminum electrolytic capacitors are divided into positive and negative electrodes, and no reverse voltage or AC voltage should be added. For circuits where reverse voltage may occur, a non-polar capacitor should be selected. Note: even without a polarity capacitor,
Nor can it be used directly in AC circuits.
(5) For circuits that require fast charge and discharge, use aluminum electrolytic capacitors that match the conditions of use. As a product of the fast charge and discharge circuit, there are a welder, a camera flash, and the like.
For aluminum electrolytic capacitors selected for fast charge and discharge circuits, you can consult us.
(6) Make sure that there is no overload voltage (voltage exceeding the rated voltage) through the capacitor.
1 The peak voltage after the superposition of DC voltage and ripple current should not exceed the rated operating voltage.
2 If more than two capacitors are connected in series, make sure that the applied voltage is lower than the rated value, and a balancing resistor should be connected in parallel so that the applied voltage of each capacitor is equal.
(7) The capacitor hose cannot guarantee insulation, and the hose on the capacitor cannot be used for insulation. If you have insulation requirements, please contact our sales department.

(8) If used in the following environments, it may cause a capacitor failure:
1 ambient (weather resistance) conditions
(a) An environment that is in direct contact with water, high temperature, high humidity or condensation.
(b) An environment that is in direct contact with oil or is filled with oil mist.
(c) An environment that is in direct contact with salt water or is salty.
(d) An environment filled with toxic gases such as hydrogen sulfide, sulfurous acid, chlorine, bromine, methyl bromide, ammonia, etc.
(e) In an environment exposed to sunlight, ozone, ultraviolet light or radiation.
(f) An environment that is in direct contact with an acidic or alkaline solvent.
2 Severe vibration and mechanical shocks exceed the scope of the company's product catalog.
The test conditions for vibration are as follows:
Vibration frequency range: 10 ~ 55 ~ 10HZ
Vibration cycle frequency: 10 ~ 55 ~ 10HZ / minute
Vibration circumference frequency: logarithm
Amplitude or acceleration: 1.5MM (maximum acceleration is 10G)
Vibration direction: X, Y, Z direction
Test time: 2 hours in each direction
Impact is generally not applicable.