nrf52840 VDD 设置为3.3V 方法

 

 

static int board_nrf52840_high_voltage_set()
{
    //sd_power_dcdc_mode_set(NRF_POWER_DCDC_ENABLE);
    //sd_power_dcdc0_mode_set(NRF_POWER_DCDC_ENABLE);

    /* if the nrf52840_pca10059 board is powered from USB
     * (high voltage mode), GPIO output voltage is set to 1.8 volts by
     * default and that is not enough to turn the green and blue LEDs on.
     * Increase GPIO voltage to 3.0 volts.
     */
    if (((NRF_UICR->REGOUT0 & UICR_REGOUT0_VOUT_Msk) ==
         (UICR_REGOUT0_VOUT_DEFAULT << UICR_REGOUT0_VOUT_Pos))) {

        NRF_NVMC->CONFIG = NVMC_CONFIG_WEN_Wen << NVMC_CONFIG_WEN_Pos;
        while (NRF_NVMC->READY == NVMC_READY_READY_Busy) {
            ;
        }

        NRF_UICR->REGOUT0 =
            (NRF_UICR->REGOUT0 & ~((uint32_t)UICR_REGOUT0_VOUT_Msk)) |
            (UICR_REGOUT0_VOUT_3V3 << UICR_REGOUT0_VOUT_Pos);

        NRF_NVMC->CONFIG = NVMC_CONFIG_WEN_Ren << NVMC_CONFIG_WEN_Pos;
        while (NRF_NVMC->READY == NVMC_READY_READY_Busy) {
            ;
        }

        /* a reset is required for changes to take effect */
        NVIC_SystemReset();
    }

    return 0;
}