思科路由器基本配置与常用配置命令(simple for CCNA)

本文详细介绍了思科路由器的基本配置和常用命令,包括启动接口、分配IP地址、配置RIP、IGRP、IPX路由协议,以及设置DDR、ISDN、Frame Relay等。此外,还涵盖了配置ACL、PPP认证、DCE时钟、主机名、密码安全和跟踪路由等实用操作。
摘要由CSDN通过智能技术生成
思科路由器基本配置与常用配置命令(simple for CCNA)启动接口,分配IP地址:router>router> enablerouter#router# configure terminalrouter(config)#router(config)# interface Type Portrouter(config-if)# no shutdownrouter(config-if)# ip address IP-Address Subnet-Maskrouter(config-if)# ^z配置RIP路由协议:30秒更新一次router(config)# router riprouter(config-if)# network Network-Number <--通告标准A,B,C类网-->router(config-if)# ^z配置IGRP路由协议:90秒更新一次router(config)# router igrp AS-Number <-- AS-Number范围1~65535-->router(config-if)# network Network-Number <--通告标准A,B,C类网-->router(config-if)# ^z配置Novell IPX路由协议:Novell RIP 60秒更新一次router(config)# ipx routing [node address]router(config)# ipx maximum-paths Paths <--设置负载平衡,范围1~512-->router(config)# interface Type Portrouter(config-if)# ipx network Network-Number [encapsulation encapsulation-type] [secondary] <--通告标准A,B,C类网-->router(config-if)# ^z配置DDR:router(config)# dialer-list Group-Number protocol Protocol-Type permit [list ACL-Number]router(config)# interface bri 0router(config-if)# dialer-group Group-Numberrouter(config-if)# dialer map Protocol-Type Next-Hop-Address name Hostname Telphone-Numberrouter(config-if)# ^z配置ISDN:router(config)# isdn swith-type Swith-Type <--配置ISDN交换机类型,中国使用basic-net3-->router(config-if)# ^z配置Frame Relay:router(config-if)# encapsulation frame-relay [cisco | ietf ]router(config-if)# frame-relay lmi-type [ansi | cisco | q933a ]router(config-if)# bandwidth kilobitsrouter(config-if)# frame-relay invers-arp [ Protocol ] [dlci ]<--配置静态Invers ARP表:router(config)# frame-relay Protocol Protocol-Address DLCI [ Broadcast ] [ ietf | cisco ] [ payload-compress | packet-by-packet ]--><--设置Keepalive间隔:router(config-if)# keepalive Number--><--为本地接口指定DLCI:router(config-if)# frame-lelay local-dlci Number--><--子接口配置:router(config-if)# interface Type Port.Subininterface-Number [ multipoint | point-to-point ]router(config-subif)# ip unnumbered Interfacerouter(config-subif)# frame-lelay local-dlci Number-->router(config-if)# ^z配置标准ACL:router(config)# access-list Access-List-Number [ permit | deny ] source [ source-mask ] <-- Access-List-Number 范围ÿ
评论
添加红包

请填写红包祝福语或标题

红包个数最小为10个

红包金额最低5元

当前余额3.43前往充值 >
需支付:10.00
成就一亿技术人!
领取后你会自动成为博主和红包主的粉丝 规则
hope_wisdom
发出的红包
实付
使用余额支付
点击重新获取
扫码支付
钱包余额 0

抵扣说明:

1.余额是钱包充值的虚拟货币,按照1:1的比例进行支付金额的抵扣。
2.余额无法直接购买下载,可以购买VIP、付费专栏及课程。

余额充值