How to program SPI Flash through LT768x - Using STM32F103x as the host MCU

本文链接：https://blog.csdn.net/2401_83817343/article/details/138798360

1. Introduction

In LT768x applications, an SPI Flash is often used to store pre-designed images, animations, and fonts etc. This manual is to illustrate how users may utilize an STM32 MCU to program such image data to an SPI Flash that is connected to an LT768x chip.

2. Programming Procedure

Step 1: Contact Levetop for the MCU source code (based on STM32F103x), and program it to the MCU board. In the code, two buttons (KEY0 & KEY1) are designed to work as below:

KEY0: Erase the flash chip

KEY1: Retrieve and print out the first 100 data bytes stored in the flash

Step 2: Connect the MCU board to LT768x controller board

Step 3: Connect the MCU board to computer through Uart port

Step 4: Power on the MCU board

Step 5: Activate the Uart tool (using 正点原子 ATK-XCOM.exe as an exmple), and set related parameters.

Please note that the baud-rate must be set as same as the MCU code setting.

Step 6: Open the Uart connection, the Uart tool window will show as below after running the MCU code:

Step 7: Press KEY0 to erase the flash chip. This operation will take some time. Please note that the flash chip must be erased before programming new data to it.