BEA-000342 this server is unable to establish a connection to the node manager

异常信息:

<2011-1-13 下午09时21分44秒 CST> <Warning> <Security> <BEA-090504> <Certificate chain received from localhost - 127.0.0.1 failed hostname verification check. Certificate contained imep1 but check expected localhost> 
<2011-1-13 下午09时21分44秒 CST> <Warning> <NodeManager> <BEA-300038> <The node manager is unable to monitor this server. Could not create an SSL connection to the node manager. Reason : [Security:090504]Certificate chain received from localhost - 127.0.0.1 failed hostname verification check. Certificate contained imep1 but check expected localhost> 
<2011-1-13 下午09时21分44秒 CST> <Emergency> <WebLogicServer> <BEA-000342> <Unable to initialize the server: weblogic.management.configuration.ConfigurationException: Due to faulty SSL configuration, this server is unable to establish a connection to the node manager.> 
***************************************************************************
The WebLogic Server did not start up properly.
Exception raised: 'weblogic.management.configuration.ConfigurationException: Due to faulty SSL configuration, this server is unable to establish a connection to the node manager.'
Reason: weblogic.management.configuration.ConfigurationException: Due to faulty SSL configuration, this server is unable to establish a connection to the node manager.
***************************************************************************

解决方案1(推荐)：
解除host1的weblogic文件共享；
同时重装host2上的weblogic。
然后，在按本文档前面有关主机2上主机的操作进行即可。
解决方案2：
进入http://localhost:9001/console；
打开portalClusterDomain> Servers> adminServer，进入Configuration 的 Keystores & SSL，展开Advanced Options，将 Hostname Verification的值改为”None”；
打开portalClusterDomain> Servers> host2-server1，进入Configuration 的 Keystores & SSL，展开Advanced Options，将 Hostname Verification的值改为”None”；
打开portalClusterDomain> Servers> host2-server2，进入Configuration 的 Keystores & SSL，展开Advanced Options，将 Hostname Verification的值改为”None”；
注意：上面操作中只修改了adminServer、host2-server1、host2-server2，没有对host1-server1、host2-server2进行修改，因为，host2-server1、host2-server2本身就是在host1主机上，可以不修改。
解决方案3：
给host1主机上的startWebLogic.sh添加如下启动参数：-Dweblogic.security.SSL.ignoreHostnameVerification=true
同时，在控制台，为host2-server1、host2-server2增加启动参数：-Dweblogic.security.SSL.ignoreHostnameVerification=true