ospf综合实验

首先对r3，r5,r6,r7配置

[Huawei]sys r3 
[r3]interface Serial 4/0/1
[r3-Serial4/0/1]ip address 34.0.0.1 24

[Huawei]sys r5
[r5]interface Serial 4/0/0
[r5-Serial4/0/0]ip address  45.0.0.1 24

[Huawei]sys r6
[r6]interface Serial 4/0/0
[r6-Serial4/0/0]ip address 46.0.0.1 24

[Huawei]sys r7
[r7]interface GigabitEthernet 0/0/0
[r7-GigabitEthernet0/0/0]ip address 47.0.0.1 24

然后对r5进行环回配置
[r5]interface LoopBack 0
[r5-LoopBack0]ip address 172.16.2.1 24
    
[r5]interface Tunnel 0/0/0
[r5-Tunnel0/0/0]tunnel-protocol gre p2mp 
[r5-Tunnel0/0/0]ip address 172.16.1.1 29

对R6和R7进行同样操作
对R3进行

[r3]interface Tunnel 0/0/0

[r3-Tunnel0/0/0]tunnel-protocol gre p2mp 

[r3-Tunnel0/0/0]display this 
[V200R003C00]
#
interface Tunnel0/0/0
 tunnel-protocol gre p2mp
#

[r3-Tunnel0/0/0]ip address 172.16.1.4  29
然后对        R1,R2,R3配置

对R3配置完之后，可以ping一下检查是否成功

对        R6,R11，R12进行ip配置，检测

对        R12创建一个环回
[r12]interface LoopBack 0
[r12-LoopBack0]ip address 172.16.66.1 24

其余路由器如上配置

对        R4配置

对路由器写缺省

[r3]ip route-static 0.0.0.0 0 34.0.0.2

[r5]ip route-static 0.0.0.0 0 45.0.0.2

[r6]ip route-static 0.0.0.0 0 46.0.0.2

[r7]ip route-static 0.0.0.0 0 47.0.0.2

可以看出配置ip没有问题

对R3配置MGRE环境

看R7的nhrp配置

对R3的hnrp进行查看，MGRE环境完成

ospf以R5为例