VRRP 负载均衡

 

 

 

 

 

实现vrrp负载均衡   首先
1、给每台交换机改名 配置VLAN 2
<Huawei>system-view 
[Huawei]undo info-center enable 
[Huawei]sysname sw4
[sw4]vlan 2             #其余三台配置相同

配置trunk
[sw3-Ethernet0/0/1]in e0/0/2
[sw3-Ethernet0/0/2]port link-t    
[sw3-Ethernet0/0/2]port link-type trunk
[sw3-Ethernet0/0/2]port trunk allo    
[sw3-Ethernet0/0/2]port trunk allow-pass vlan al

配置所有接口为trunk
多接口可以用接口组将接口加入VLAN
[sw4]port-group 1    
[sw4-port-group-1]group-member Ethernet 0/0/1 Ethernet 0/0/2
配置完成

如果配错 将接口回复默认
[sw4]clear configuration interface GigabitEthernet 0/0/1 
Warning: All configurations of the interface will be cleared, and its state will
 be shutdown. Continue? [Y/N] :y
Info: Total execute 2 command(s), 2 successful, 0 failed.

display this  #查看当前配置
**********************注意：看清交换机接口三层交换G口，交换机E口
[sw1-Vlanif1]in vlan 2    
[sw1-Vlanif2]ip address 192.168.2.252 24    #进入VLAN配IP
配完ping测试

配置VRRP第一个交换机
sw1   vlan1 主   VLAN2 备
sw2   VLAN2 主    VLAN1 备
[sw1]in vlan 1    
[sw1-Vlanif1]vrrp vrid 1 virtual-ip 192.168.1.254
[sw1-Vlanif1]vrrp vrid 1 priority 105
[sw1-Vlanif1]in vlan 2    
[sw1-Vlanif2]vrrp vrid 2 virtual-ip 192.168.2.254
display vrrp brief 查看

 

第二个交换机
[sw2]in vlan 1    
[sw2-Vlanif1]vrrp vrid 1 virtual-ip 192.168.1.254
[sw2-Vlanif1]in vlan 2    
[sw2-Vlanif2]vrrp vrid 2 virtual-ip 192.168.2.254

[sw2-Vlanif2]vrrp vrid 1 priority 105
display vrrp brief 查看