报告控制块中 RptEnabled 对于多个客户机的实例化要求

最新推荐文章于 2024-08-18 21:29:07 发布

NullXie

最新推荐文章于 2024-08-18 21:29:07 发布

阅读量1.6k

点赞数

分类专栏： IEC61850 文章标签： associations report attributes generation system list

本文链接：https://blog.csdn.net/NullXie/article/details/6288470

版权

报告控制块（RCB）遵循IEC 61850-7-2标准，一次只能服务于一个客户端。若RptEnabled的Max>1，IED需为每个多余的客户端实例化一个RCB。每个缓冲控制块的ClientLN需预配置，对于非缓冲RCB，还需设置Resv属性。报告控制块定义在SCL中被视为类型而非实例，如有99个客户端则需生成99个实例。实例名称由类型名称加01到Max的数字组成。ClientLN元素定义系统中报告CB类型的客户端LN名称。此外，确保定义的客户端可通过定义的通信系统访问。

摘要由CSDN通过智能技术生成

The element RptEnabled is defined as follows:

The RptEnabled element contains the list of client LNs for which this report shall be enabled
(for example at IED startup on pre-established associations).

The attributes given in Table 23 are used.

According to IEC 61850-7-2, a report control block is dedicated to at most one client at a time.
This means that if Max > 1 is given for RptEnabled, more than one report control block (RCB) of
this type has to be instantiated in the IED. Observe that for all buffered control blocks, a ClientLN
shall be preconfigured, i.e. Max is identical to the number of ClientLNs given. If ClientLNs are
preconfigured for un