OFED下载地址:http://downloads.openfabrics.org/OFED/
此文档只作为快速安装参考,详细OFED安装请参考软件中的
README.txt文件。
操作系统: CentOS 6.3 x64
HCA及交换机硬件提供商: 迈络思
一.安装步骤
1.安装依赖组
yum groupinstall "Infiniband Support" -y
2.安装依赖包
yum install -y gcc glibc-devel zlib-devel libstdc++-devel gcc-c++ libtool bison flex tcl-devel tcsh kernel-devel rpm-build make pciutils openssh-clients
openssh-clients并不是必须的,这里只是为了使用scp命令。
3.执行安装
tar -xvzf OFED-1.5.4-rc5.tgz
cd ..
./install
依次输入(未打开srp支持)
2 2 1 y y n
4.以下信息只需确认,所以直接回车
The default IPoIB interface configuration is based on DHCP.
Note that a special patch for DHCP is required for supporting IPoIB.
The patch is available under docs/dhcp
If you do not have DHCP, you must change this configuration in the following steps.
IPoIB interfaces configured successfully
Press any key to continue ...
Press any key to continue ...
Device (15b3:1003):
04:00.0 Network controller: Mellanox Technologies MT27500 Family [ConnectX-3]
Link Width: 8x
PCI Link Speed: 40
Installation finished successfully.
Press any key to continue...
5.退出安装
OFED Distribution Software Installation Menu
1) View OFED Installation Guide
2) Install OFED Software
3) Show Installed Software
4) Configure IPoIB
5) Uninstall OFED Software
Q) Exit
Select Option [1-5]:q
Exiting
二.安装后配置hca卡
1.hca口绑定
[root@dntodu001 network-scripts]# cat ifcfg-ib0
DEVICE=ib0
USERCTL=no
ONBOOT=yes
MASTER=bondib0
SLAVE=yes
BOOTPROTO=none
HOTPLUG=no
IPV6INIT=no
CONNECTED_MODE=yes
MTU=65520
[root@dntodu001 network-scripts]# cat ifcfg-ib1
DEVICE=i
此文档只作为快速安装参考,详细OFED安装请参考软件中的
README.txt文件。
操作系统: CentOS 6.3 x64
HCA及交换机硬件提供商: 迈络思
一.安装步骤
1.安装依赖组
yum groupinstall "Infiniband Support" -y
2.安装依赖包
yum install -y gcc glibc-devel zlib-devel libstdc++-devel gcc-c++ libtool bison flex tcl-devel tcsh kernel-devel rpm-build make pciutils openssh-clients
openssh-clients并不是必须的,这里只是为了使用scp命令。
3.执行安装
tar -xvzf OFED-1.5.4-rc5.tgz
cd ..
./install
依次输入(未打开srp支持)
2 2 1 y y n
4.以下信息只需确认,所以直接回车
The default IPoIB interface configuration is based on DHCP.
Note that a special patch for DHCP is required for supporting IPoIB.
The patch is available under docs/dhcp
If you do not have DHCP, you must change this configuration in the following steps.
IPoIB interfaces configured successfully
Press any key to continue ...
Press any key to continue ...
Device (15b3:1003):
04:00.0 Network controller: Mellanox Technologies MT27500 Family [ConnectX-3]
Link Width: 8x
PCI Link Speed: 40
Installation finished successfully.
Press any key to continue...
5.退出安装
OFED Distribution Software Installation Menu
1) View OFED Installation Guide
2) Install OFED Software
3) Show Installed Software
4) Configure IPoIB
5) Uninstall OFED Software
Q) Exit
Select Option [1-5]:q
Exiting
二.安装后配置hca卡
1.hca口绑定
[root@dntodu001 network-scripts]# cat ifcfg-ib0
DEVICE=ib0
USERCTL=no
ONBOOT=yes
MASTER=bondib0
SLAVE=yes
BOOTPROTO=none
HOTPLUG=no
IPV6INIT=no
CONNECTED_MODE=yes
MTU=65520
[root@dntodu001 network-scripts]# cat ifcfg-ib1
DEVICE=i