General Introduction of the Spiral Grading Machine

Spiral classifier is one of essential equipments in the production line , its wide application and simple operation are all make it become an important mine auxiliary equipment :

Spiral classifier work principle:
Since the solid particles sizes are different, specific gravities are different, and thus the settling velocities in the liquid are different , that is to say, the fine mineral particles floating on the water surface, and flow out with water, the coarse ore particles sink to the bottom. According to this principle, spiral sorting machine discharges the ore grain by the classifier, so we can say spiral classifier is a classifying equipment that used to classify machine. It screens the materials that grand by the  mill, and then  screw the coarse materials in the mill feeding port by the screw sheet , finally, the fine materials that produced by the mill are discharged by the overflow pipe.

The application of spiral classifier :
Grading machine is widely applied to the concentrators. It can works with the   mill and form the closed circuits to process shunt mineral sands,  to grade ore and fine mud in the gravity concentrators ,   particle size classification the metal beneficiation processes of pulp, and desliming job washing, dehydration and other operations. This machine has  simple structure, reliable, easy to operate these advantages.

Installation of spiral classifier:
after the pallidum begin to rotate, we can feed into the pulp, and increase the pulp amount gradually. 2.when the spirochetes  works, if some emergencies happens, such as   stuck ,overload,and so on) the machine should be immediately stopped , enhance the spirochete  from the pulp surface , because it isn't  permitted spirochete is pressed in the pulp , open the ore valve immediately  to avoid blockage. 3,when starting again, the spiral body shall be decreased to a certain position, only in this way,we can rotate the spiral body. 4, when the machine is in use,if  the parking is required, we should first stop feeding   material ,after we assure there is no materials inside, can we stop work completely.

The maintenance methods  of spiral classifier :
1, all lubrication points should use sodium grease or calcium-based grease lubrication, but note that the oil temperature should not be too high. 2, each class should view whether the lubricants of the inside of the reducer  are engraved in oil needle online. Change oil every six months. 3. We Should often check whether  the lower seat or  the middle frame bearing, bearings, seals for wear, the bearing are damaged or not for replacing  timely . 4, As to the bearing lubrication, we must manually press the high pressure oil to the bearing through the dry oil pump , only in this way, we can keep the seeling of the bearing.

 

转载于:https://www.cnblogs.com/dvbcxb/archive/2012/09/04/2670334.html