使用Freescale提供的脚本对Micro SD卡进行分区和编程时，有时无法成功引导内核。U-Boot显示错误如'booti: bad boot image magic'。通过尝试使用dd命令重新编程启动分区，最终解决了启动问题。
Using freescale supplied script to partition and program an SD card (Micro SD, TF card) sometimes it's can't
boot kernel successfully, just as following:
U-Boot 2014.04 (Jun 23 2015 - 16:10:39)
CPU: Freescale i.MX6Q rev1.2 at 792 MHz
CPU: Temperature 44 C, calibration data: 0x5584ae7d
Reset cause: POR
Board: MX6-SabreSD
I2C: ready
DRAM: 1 GiB
MMC: FSL_SDHC: 0, FSL_SDHC: 1
SF: Unsupported flash IDs: manuf 00, jedec 0000, ext_jedec 0000
*** Warning - spi_flash_probe() failed, using default environment
Display: HDMI (640x480)
In: serial
Out: serial
Err: serial
unsupported boot devices
check_and_clean: reg 0, flag_set 0
Fastboot: Normal
flash target is MMC:1
Net: Phy not found
PHY reset t
最低0.47元/天 解锁文章
扫一扫
2795
被折叠的 条评论
为什么被折叠?
到【灌水乐园】发言
