redis远程连接与密码验证

最新推荐文章于 2024-08-19 04:12:05 发布

baidu_36030459

最新推荐文章于 2024-08-19 04:12:05 发布

阅读量2.5w

点赞数 4

本文链接：https://blog.csdn.net/baidu_36030459/article/details/55253092

版权

本文介绍了如何开启Redis的远程访问并设置密码验证。通过修改配置文件或使用命令行工具，可以设置`requirepass`以保护Redis实例。此外，还展示了在不同情况下正确连接Redis并进行权限验证的方法。

摘要由CSDN通过智能技术生成

redis开启远程访问

redis默认只允许本地访问，要使redis可以远程访问可以修改redis.conf

打开redis.conf文件在 NETWORK部分有说明

解决办法：注释掉bind 127.0.0.1可以使所有的ip访问redis

若是想指定多个ip访问，但并不是全部的ip访问，可以bind

注意

下面还有个说明

在redis3.2之后，redis增加了protected-mode，在这个模式下，即使注释掉了bind 127.0.0.1，再访问redisd时候还是报错，如下

(error) DENIED Redis is running in protected mode because protected mode is enabled, no bind address was specified, no authentication password is requested to clients. In this mode connections are only accepted from the loopback interface. If you want to connect from external computers to Redis you may adopt one of the following solutions: 1) Just disable protected mode sending the command 'CONFIG SET protected-mode no' from the loopback interface by connecting to Redis from the same host the server is running, however MAKE SURE Redis is not publicly accessible from internet if you do so. Use CONFIG REWRITE to make this change permanent. 2) Alternatively you can just disable the protected mode by editing the Redis configuration file, and setting the protected mode option to 'no', and then restarting the server. 3) If you started the server manually just for testing, restart it with the '--protected-mode no' option. 4) Setup a bind address or an authentication password. NOTE: You only need to do one of the above things in order for the server to start accepting connections from the outside.