我的第一个简单的linux打印输出驱动（文件自动注册有问题）

平台：linux 2.6.28.7
#include <linux/module.h>
#include <linux/kernel.h>
#include <linux/fs.h>
#include <linux/init.h>
#include <linux/device.h>
#include <linux/miscdevice.h>
#include <linux/delay.h>
#include <asm/irq.h>
/*
#include <asm/arch/regs-gpio.h>
#include <asm/hardware.h>

#include <linux/config.h>
#include <linux/devfs_fs_kernel.h>
*/
static struct class *firstdrv_class;
static struct class_device *firstdrv_class_dev;
int major;
static int first_driver_open(struct inode *inode,struct file *file)//打开文件
{
printk("This is my first driver test!!!\n");
return 0;
}
static ssize_t  first_driver_write(struct file *file,const __user *buf,size_t count,loff_t *ppos)//打印输出
{
printk("My first driver is writing....\n");
return 0;

}

//入口结构体

static struct file_operations  first_driver_fops = {
.owner = THIS_MODULE,
.open = first_driver_open,
.write = first_driver_write,
};
//注册入内核
int first_driver_init(void)
{
register_chrdev(0,"first_drv",&first_driver_fops);
firstdrv_class = class_create(THIS_MODULE, "first_drv");
if(IS_ERR(firstdrv_class))
printk("firstdrv_class creates error! \n");
firstdrv_class_dev = device_create(firstdrv_class, NULL, MKDEV(major, 0), NULL, "xyz"); /* /dev/xyz */
if(unlikely(IS_ERR(firstdrv_class)))
printk("/dev/xyz  creates error! \n");
return 0;

}

void  first_driver_exit(void)
{
unregister_chrdev(0,"first_drv");
device_unregister(firstdrv_class_dev);
class_destroy(firstdrv_class);
}
module_init(first_driver_init);
module_exit(first_driver_exit);
MODULE_LICENSE("GPL");                              // 遵循的协议

注意：在firstdrv_class_dev = device_create(firstdrv_class, NULL, MKDEV(major, 0), NULL, "xyz"); 出不起作用，注册驱动后不能自动生成文件，还得手动加入。

查资料修改/etc/init.d/rcS（要在超级终端下VI修改，否则启动打不开此文件了）。其中添加echo /sbin/mdev > /proc/sys/kernel/hotplug还是不行，求大家帮忙解决？？