宏途_LCD调试流程.

今天在调试宏途的LCD屏时，开始是开机屏幕不亮，背光都不亮，可能板子已经损坏，一般通过测试电流电压简单验证，(注：硬件引脚没焊好也会引起读lcd id出现错误！！！)出现这个问题一般是因为引脚没焊好，可以找硬件帮忙；

 

焊接好后背光点亮，但是一直停在logo区，无法进入系统，如果logo显示不正常，这个原因一般是u-boot读不对lcd id导致加载kernel加载不了lcd驱动导致kernel死掉！；

U-Boot 2010.12-00001-gf3d69f8-dirty (Aug 222013 - 15:20:30)                           

                                                                            

DRAM: 256 MiB                                                              

NAND: The type of nand flash is 2KB page, so use default configuration!

512 MiB                                

MMC:  after set sd clk, CLK_GEN5:60000

mv_sdh: 0                              

Using default environment              

In:   serial

Out:  serial

Err:  serial

sci_efuse_calibration data:0

is_bat_low adc_value:784,comp_vbat:3500

mingwei ubootvol:3546,adc4200:928,adc3600:796

GEN0 1d382360

Bad block table found at page 262080,version 0x03

Bad block table found at page 262016,version 0x03

nand_read_bbt: Bad block at 0x00001f700000

nand_read_bbt: Bad block at 0x00001f780000

ANA_RTC_INT_RSTS is 0x820000b4

value of it 0x1

calibrate detecting

U-Boot 2010.12-00001-gf3d69f8-dirty (Aug 222013 - 15:20:30)

DRAM: 256 MiB

NAND: The type of nand flash is 2KB page, so use default configuration!

512 MiB

MMC:  after set sd clk, CLK_GEN5:60000

mv_sdh: 0

Using default environment

 In:   serial

Out:  serial

Err:  serial

sci_efuse_calibration data:0

is_bat_low adc_value:783,comp_vbat:3500

mingwei ubootvol:3541,adc4200:928,adc3600:796

GEN0 1d382360

Bad block table found at page 262080,version 0x03

Bad block table found at page 262016,version 0x03

nand_read_bbt: Bad block at 0x00001f700000

nand_read_bbt: Bad block at 0x00001f780000

ANA_RTC_INT_RSTS is 0x820000b4

value of it 0x0

calibrate detecting

 U-Boot 2010.12-00001-gf3d69f8-d