C flag:For a subtraction, including the comparison instruction CMP, C is set to 0 if the subtraction produced a borrow (that is, an unsigned underflow), and to 1 otherwise.
Z flag: Is set to 1 if the result of the instruction is zero (which often indicates an equal result from
a comparison), and to 0 otherwise.
In either case, the new condition code flags (after the instruction has been executed) usually mean:
N Is set to bit 31 of the result of the instruction. If this result is regarded as a two's complement
signed integer, then N = 1 if the result is negative and N = 0 if it is positive or zero.
Z Is set to 1 if the result of the instruction is zero (which often indicates an equal result from
a comparison), and to 0 otherwise.
C Is set in one of four ways:
• For an addition, including the comparison instruction CMN, C is set to 1 if the addition
produced a carry (that is, an unsigned overflow), and to 0 otherwise.
• For a subtraction, including the comparison instruction CMP, C is set to 0 if the
subtraction produced a borrow (that is, an unsigned underflow), and to 1 otherwise.
• For non-addition/subtractions that incorporate a shift operation, C is set to the last bit
shifted out of the value by the shifter.
• For other non-addition/subtractions, C is normally left unchanged (but see the
individual instruction descriptions for any special cases).
V Is set in one of two ways:
• For an addition or subtraction, V is set to 1 if signed overflow occurred, regarding the
operands and result as two's complement signed integers.
• For non-addition/subtractions, V is normally left unchanged (but see the individual
Z flag: Is set to 1 if the result of the instruction is zero (which often indicates an equal result from
a comparison), and to 0 otherwise.
In either case, the new condition code flags (after the instruction has been executed) usually mean:
N Is set to bit 31 of the result of the instruction. If this result is regarded as a two's complement
signed integer, then N = 1 if the result is negative and N = 0 if it is positive or zero.
Z Is set to 1 if the result of the instruction is zero (which often indicates an equal result from
a comparison), and to 0 otherwise.
C Is set in one of four ways:
• For an addition, including the comparison instruction CMN, C is set to 1 if the addition
produced a carry (that is, an unsigned overflow), and to 0 otherwise.
• For a subtraction, including the comparison instruction CMP, C is set to 0 if the
subtraction produced a borrow (that is, an unsigned underflow), and to 1 otherwise.
• For non-addition/subtractions that incorporate a shift operation, C is set to the last bit
shifted out of the value by the shifter.
• For other non-addition/subtractions, C is normally left unchanged (but see the
individual instruction descriptions for any special cases).
V Is set in one of two ways:
• For an addition or subtraction, V is set to 1 if signed overflow occurred, regarding the
operands and result as two's complement signed integers.
• For non-addition/subtractions, V is normally left unchanged (but see the individual
instruction descriptions for any special cases).
扫一扫
1965
被折叠的 条评论
为什么被折叠?
到【灌水乐园】发言
