有的交换机在将端口设置为trunk的时候会报这个错误,
Command rejected: An interface whose trunk encapsulation is "Auto" can not be configured to "trunk" mode.
出现这个错误的时候,先给端口封装dot1Q协议,再切换为trunk模式就OK了。
命令如下
Switch(config-if)#switchport trunk encapsulation dot1q
有的交换机在将端口设置为trunk的时候会报这个错误,
Command rejected: An interface whose trunk encapsulation is "Auto" can not be configured to "trunk" mode.
出现这个错误的时候,先给端口封装dot1Q协议,再切换为trunk模式就OK了。
命令如下
Switch(config-if)#switchport trunk encapsulation dot1q