Open the engine compartment and find the fuse box. The fuse box cover is printed with the fuse and the relay in the fuse box. Here we mainly check the next petrol pump fuses and relays. Find the petrol pump fuse, pull out, with a multimeter diode block to measure whether the fuse leads, conduction, then said no burn. After the actual measurement, to prove that the fuse is no problem. Next, I want to measure whether the relay burns. A relay is a "switch" that uses a smaller current to control a larger current, and it is necessary to apply a voltage signal to verify its quality. Because there is no suitable equipment around, I put the pump relay and the front fog lamp relay (two relays are the same), and then open the fog to see if the normal to verify the relay is good or bad. Gasoline pump dismantling more trouble, I check the method is to use the OBD diagnostic tool to activate the petrol pump alone, from the petrol pump when the sound issued to determine whether it is damaged.
来自 “ ITPUB博客 ” ,链接:http://blog.itpub.net/30200434/viewspace-2135776/,如需转载,请注明出处,否则将追究法律责任。
转载于:http://blog.itpub.net/30200434/viewspace-2135776/