LAMP-系统设置-网络设置

 1.-------------------------------------------------------------------

设置IP地址：

方法1：配置文件写入方法

[root@localhost 3]# vi /etc/sysconfig/network-scripts/ifcfg-eth0

[root@localhost 3]# vi /etc/sysconfig/network-scripts/ifcfg-eth0 
# Advanced Micro Devices [AMD] 79c970 [PCnet32 LANCE]
DEVICE=eth0
BOOTPROTO=dhcp
HWADDR=00:0C:29:6C:7F:B6
ONBOOT=yes

 

这样的设置时是自动DHCP获取IP地址

如果想手动设置：

[root@localhost 3]# vi /etc/sysconfig/network-scripts/ifcfg-eth0 
# Advanced Micro Devices [AMD] 79c970 [PCnet32 LANCE]
DEVICE=eth0
BOOTPROTO=static
HWADDR=00:0C:29:6C:7F:B6
ONBOOT=yes
NETWORK=192.168.5.0
BROADCAST=192.168.5.255
NETMASK=255.255.255.0
IPADDR=192.168.5.110

[root@localhost 3]# service network restart
Shutting down interface eth0:                              [  OK  ]
Shutting down loopback interface:                          [  OK  ]
Bringing up loopback interface:                            [  OK  ]
Bringing up interface eth0:  
Determining IP information for eth0... done.
                                                           [  OK  ]
[root@localhost 3]# 

查看IP地址：
[root@localhost 3]# ifconfig
eth0      Link encap:Ethernet  HWaddr 00:0C:29:6C:7F:B6  
          inet addr:192.168.5.110  Bcast:192.168.5.255  Mask:255.255.255.0
          inet6 addr: fe80::20c:29ff:fe6c:7fb6/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:40304 errors:0 dropped:0 overruns:0 frame:0
          TX packets:42033 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000 
          RX bytes:8300045 (7.9 MiB)  TX bytes:13211424 (12.5 MiB)
          Interrupt:59 Base address:0x2000 
lo        Link encap:Local Loopback  
          inet addr:127.0.0.1  Mask:255.0.0.0
          inet6 addr: ::1/128 Scope:Host
          UP LOOPBACK RUNNING  MTU:16436  Metric:1
          RX packets:1596 errors:0 dropped:0 overruns:0 frame:0
          TX packets:1596 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0 
          RX bytes:3222233 (3.0 MiB)  TX bytes:3222233 (3.0 MiB)
[root@localhost 3]# 

方法2：启动自动设置IP地址的方法

[root@localhost 3]# echo "ifconfig eth0 192.168.5.110" >> /etc/rc.d/rc.local

这样就可以设置IP地址了

 

然后局域网可以ping通了应该

 

想让我们的系统上网还要设置gateway网关和dns