在VMware的虚拟机中克隆CentOS，在重启网卡的时候报错

在VMware的虚拟机中克隆CentOS，在重启网卡的时候报错：

Shutting down loopback interface : [ OK ]Bringing up loopback interface : [ OK ]Bringing up interface eth0: Error: No suitable device found: no device found for connection 'System eth0' . [FAILED]

 

 

解决办法：

首先，打开/etc/udev/rules.d/70-persistent-net.rules内容如下面例子所示：

# This file was automatically generated by the /lib/udev/write_net_rules# program, run by the persistent-net-generator.rules rules file.## You can modify it, as long as you keep each rule on a single# line, and change only the value of the NAME= key.# PCI device 0x8086 : 0x100f (e1000)SUBSYSTEM== "net" , ACTION== "add" , DRIVERS== "?*" , ATTR{address}== "00:0c:29:67:c5:e2" , ATTR{type}== "1" , KERNEL== "eth*" , NAME= "eth0" # PCI device 0x8086 : 0x100f (e1000)SUBSYSTEM== "net" , ACTION== "add" , DRIVERS== "?*" , ATTR{address}== "00:0c:29:75:d1:d7" , ATTR{type}== "1" , KERNEL== "eth*" , NAME= "eth1"

 

我们看系统中eth0的配置：

#cat ifcfg-eth0DEVICE=eth0HWADDR= 00 :0C: 29 : 67 :C5:E2TYPE=EthernetUUID=5cb1d564-a7e8-4b57-bdb4-7e76e92f460aONBOOT=yesNM_CONTROLLED=yesBOOTPROTO=dhcp

也就是说，克隆的时候把网卡的MAC地址也克隆了，导致了有两个系统有相同的MAC地址。于是，要么把DEVICE=eth0改成DEVICE=eth1，然后HWADDR改成00:0c:29:75:d1:d7；

要么在70-persistent-net.rules文件中把eth0的地址改成00:0c:29:75:d1:d7，同时把eth1的配置注释掉，然后在ifcfg-eth0中修改HWADDR。之后再service network restart即可。