Enable zram&swap

Enable zram&swap

Config

CONFIG_ZRAM=y 671
CONFIG_ZSMALLOC=y

Method 1.
1)fstab.qcom
/dev/block/zram0 none swap defaults zramsize=536870912
2)init.target.rc
write /proc/sys/vm/swappiness 60
swapon_all fstab.qcom


Method 2.
kernel/drivers/staging/zram/zram.txt
19Following shows a typical sequence of steps for using zram.
20
211) Load Module:
22 modprobe zram num_devices=4
23 This creates 4 devices: /dev/zram{0,1,2,3}
24 (num_devices parameter is optional. Default: 1)
25
262) Set Disksize
27        Set disk size by writing the value to sysfs node 'disksize'.
28        The value can be either in bytes or you can use mem suffixes.
29        Examples:
30            # Initialize /dev/zram0 with 50MB disksize
31            echo $((50*1024*1024)) > /sys/block/zram0/disksize
32
33            # Using mem suffixes
34            echo 256K > /sys/block/zram0/disksize
35            echo 512M > /sys/block/zram0/disksize
36            echo 1G > /sys/block/zram0/disksize
37
383) Activate:
39 mkswap /dev/zram0
40 swapon /dev/zram0
41