| Multi user mode |
|----------------------------------------------------------------|
/|/ /|/ | | | /|/
| | | | | |
| boot shutdown | | |
| | | | | |
| ________|_________/_/________ shutdown -h | |
| | single user mode | | | shutdown -r
| |----------------------------| | | |
| | | | | |
| | | reboot -h | | |
| | | | | |
reboot | _______/_/______________/_/ | |
| | | Halt state | | |
| | |-------------------| | |
| | | | |
| | | power off | |
| | | | |
|______| | |_______|
______________________/_/________________________________________
| power off |
|---------------------------------------------------------------|
Ctrl+B 进入硬件程序环境
co 返回操作系统
rs 重启
与PDC互交,当
1 主引导磁盘引导,使用替代内核
2 主引导磁盘损坏,从备份盘引导
3 从安装介质引导,安装操作系统
与ISL交互,当
1 默认内核(/stand/vmunix)不可引导
2 引导到单用户模式,而非多用户模式
3 忘了root密码
在PDC中
boot 正常启动
boot pri isl 到ISL交互
ISL命令
到多用户模式 hpux
引导到单用户模式 hpux -is
在/stand中列出备份文件 hpux ls
指定启动内核 hpux -is /stand/vmunix.prex
显示LIF中的auto文件 hpux show autofile
指定默认内核 hpux set autofile "hpux /stand/vmnuix.a"
shutdown - ry 0 立即启动
reboot 强行重启
运行级别
0级 关闭系统
s级 单用户,使用shoudown进入
S级 单用户,VTY可访问
1级 类似于单用户,安装了文件系统,syncer在运行
2级 多用户
3级 CDE可用,NFS可用
4级 HP VUE可用
查看运行级别 who -r
在/etc/inittab中定义了进程init的参数
重新配置内核
新建内核生成三个文件
vmunix_test
dlkm.vmunix_test
system.SAM
手工升级内核
1 cp /stand/system /stand/system.prev
cp /stand/build/system.SAM stand/system
2 kmupdate /stand/build/vmunix_test
3 shutdown -ry 0
不要使用cp或mv替代kmupdate
lsdev 列出当前配置的内核驱动程序
sysdef 列出当前内核可配参数
system_prep -s system 生成内核参数文件
km_kernel -s ./system 生成内核/stand/build/vmunix_test
查看内核子系统
kmsystem | grep -e nfs -e lan
系统级别改变,升序地执行脚本,S/K脚本命名习惯S+K=1000,
可有SXXX相同的情况,此时同时启动多个服务