这个路由的CPU是BCM5352,工作在200Mhz。4MB的FLASH和16MB的RAM。板上还有JTAG和串口。
通过TFTP下载OpenWrt
Buffalo的出厂IP是192.168.11.1,你烧写之后将会变成192.168.1.1
|
rx o |
tx o |
gnd o |
vcc o |
串口波特率为115200,8位数据位,无校验位,1位停止位,ANSI终端。非RS232电平,而是+3.3V的TTL逻辑电平。可以使用使用转换芯片(Max232/Max3232/DS275 etc.) 连接。也可以使用USB转串行电话线缆。一个带有各种2303芯片的电缆可以访问路由器(比如用来查看bootloader信息)。不能用来作主机控制USB设备。VCC脚输出3.3V。
The serial port runs at 115200 baud, 8 bits, no parity, 1 stop bit using ANSI terminal emulation. Levels are not RS232 voltage levels, but +3.3V TTL logic. Use level shifter (Max232/Max3232/DS275 etc.) to correct this. Also a USB to serial phone cable will work in most cases. A cable with a Prolific 2303 works fine to access the router as a device (Eg. to get a bootloader commandline). It does not work in host mode to control USB devices. The VCC pin puts out 3.3V.