Watchdog Design

  • 1
    点赞
  • 1
    收藏
    觉得还不错? 一键收藏
  • 打赏
    打赏
  • 0
    评论
Watchdog in Verilog is a circuit or module that monitors the system's operation and ensures it is functioning properly. It is commonly used in embedded systems to detect and recover from system failures or malfunctions. The watchdog module typically consists of a timer and a reset signal. The timer counts down from a preset value, and if the timer reaches zero before being reset, it indicates a system fault, triggering a reset of the system. Here's an example of a simple watchdog module in Verilog: ```verilog module watchdog( input wire clk, // Clock input input wire enable, // Enable signal output wire reset // Reset signal ); reg [15:0] timer; // Timer counter always @(posedge clk) begin if (enable) begin timer <= timer - 1; // Decrement the timer on each clock cycle if (timer == 0) begin reset <= 1; // Assert reset signal if timer reaches zero end end else begin timer <= 0; // Reset the timer when disabled reset <= 0; // Clear the reset signal end end endmodule ``` In this example, the watchdog module takes in a clock signal (`clk`), an enable signal (`enable`), and outputs a reset signal (`reset`). The module uses an internal timer (`timer`) that decrements on each rising edge of the clock when the enable signal is active. If the timer reaches zero, it asserts the reset signal. You can instantiate this module in your Verilog design and configure the timer duration according to your system requirements. Remember to connect the clock and enable signals appropriately. Please note that this is just a basic implementation, and you may need to modify it based on your specific design needs and requirements.
评论
添加红包

请填写红包祝福语或标题

红包个数最小为10个

红包金额最低5元

当前余额3.43前往充值 >
需支付:10.00
成就一亿技术人!
领取后你会自动成为博主和红包主的粉丝 规则
hope_wisdom
发出的红包

打赏作者

suvine

你的鼓励将是我创作的最大动力

¥1 ¥2 ¥4 ¥6 ¥10 ¥20
扫码支付:¥1
获取中
扫码支付

您的余额不足,请更换扫码支付或充值

打赏作者

实付
使用余额支付
点击重新获取
扫码支付
钱包余额 0

抵扣说明:

1.余额是钱包充值的虚拟货币,按照1:1的比例进行支付金额的抵扣。
2.余额无法直接购买下载,可以购买VIP、付费专栏及课程。

余额充值