记一次安装Proxmox 7.4黑屏的成功解决

huang_gewen

已于 2024-04-26 11:41:19 修改

阅读量562

点赞数 3

分类专栏： Proxmox 文章标签： linux 运维服务器

于 2024-04-26 09:03:30 首次发布

本文链接：https://blog.csdn.net/huang_gewen/article/details/138205155

版权

Proxmox 专栏收录该内容

1 篇文章 0 订阅

订阅专栏

这篇文章讲述了用户在尝试安装Proxmox7.4时遇到显示器不同步的问题，通过在GRUB模式下修改kernel参数和编辑xorg.conf文件，解决了显示适配器驱动不支持导致的黑屏问题，使安装过程得以继续。

摘要由CSDN通过智能技术生成

Proxmox 7.4安装进入图形界面时不能驱动显示适配器，造成黑屏，无法继续安装。

解决办法来自Proxmox的论坛的一个帖子，发布者是wally_p，转载如下：

Hello. Writing here just in case if someone needs:
I had the same problem with Proxmox 7.4 and HP 360 g7. After choosing 'install proxmox' I had monitor out-of-sync - probably because not supported refresh rate. Generally hints in other posts are correct however I fought a little bit to make it work.
Below the procedure which worked for me (with old 15 inch monitor and resolution 1024x768).

The Procedure:
1. Write Proxmox on USB Key and choose to start server from USB
2. On the Proxmox Grub screen move to (highlight) option "Install Proxmox", and press 'e'
2. You are in the grub edition mode, add the following text at the end of the kernel parameters: module_blacklist=radeonfb nomodeset
3. Click F10 to continue with the installation
4. There will be a problem with the GUI and the installer will fail back to the console
5. Edit file: /usr/share/X11/xorg.conf.d/10-quirks.conf
with eg. nano edtor
> cd /usr/share/X11/xorg.conf.d/
> nano 10-quirks.conf

Add section in the file (with correct indents):

Section "Device"
ID "Card0"
Driver "fbdev"
EndSection

6. Save the file, and exit the nano editor.
7. In console run command:
xinit
8. The installer should start without problems, continue with the proxmox installation...