Step by step for LIN slave conformance test with CANoe

eeblacksmith

于 2019-10-12 10:14:52 发布

阅读量1.5k

点赞数 1

分类专栏：汽车行业文章标签： LIN

本文链接：https://blog.csdn.net/jackjones_008/article/details/102514984

版权

本文档详细介绍了如何使用CANoe进行LIN从站一致性测试。首先确保CANoe具备LIN选项并连接了LINpiggy硬件。然后，替换默认配置文件，加载实际产品LDF文件，并设置LIN通道及节点。接下来，在‘LIN slave conformance tester 1’上配置测试设置，选择从站节点并生成XML。选择要执行的测试用例，点击开始测试，最后通过报告图标获取测试报告。

摘要生成于 C知道，由 DeepSeek-R1 满血版支持，前往体验 >

There is a configuration file LINSlaveConformanceTest.cfg for LIN slave conformance test at C:\Users\Public\Documents\Vector\CANoe\Sample Configurations 11.0.55\LIN\LINSlaveConformanceTest\.

Make sure the CANoe has LIN option and has LINpiggy inside the HW. Connect the slave device with CANoe.

Base on this, we can do some modifications to perform the real LIN slave conformance test as below.

1. Modified the simulation setup, load the real LDF file for your product instead of using the dfault one. Set CANoe LIN channel and add nodes to the network.

2. Right click on the "LIN slave conformance tester 1" as below