H3C交换机配置链路聚合二层\三层

二层聚合：

一、静态聚合

[SW]int Bridge-Aggregation 1 

[SW-Ethernet1/0/1]port link-aggregation group 1

[SW-Ethernet1/0/2]port link-aggregation group 1

[SW-Bridge-Aggregation1]port link-type trunk

[SW-Bridge-Aggregation1]port  trunk permit vlan all 必须先加入端口再起Trunk，要不然会出错

二、动态聚合

[SW]int Bridge-Aggaregation 1 

[SW-Bridge-Aggregation1]link-aggregation mode dynamic 

[SW-Ethernet1/0/1]port link-aggregation group 1

[SW-Ethernet1/0/2]port link-aggregation group 1

[SW-Bridge-Aggregation1]port link-type trunk

[SW-Bridge-Aggregation1]port trunk permit vlan all

查看命令：

display link-aggregation summary

[S1]display link-aggregation verbose

 

负载分担：

[S1]link-aggregation load-sharing mode destination-mac  两端都配置（貌似接口也可以配置）

 

三层聚合：

[R2]int Route-Aggregation 1

[R2-Route-Aggregation1]ip add 12.1.1.2 24

[R2]int g0/0

[R2-GigabitEthernet0/0]port link-aggregation group 1

[R2-GigabitEthernet0/0]int g0/1

[R2-GigabitEthernet0/1]port link-aggregation group 1

 

负载分担：

[R1]link-aggregation global load-sharing mode source-ip destination-ip基于源IP，目的IP

转载自：清风竹_fu