CentOS Linux解决Device eth0 does not seem to be present

CentOS Linux解决Device eth0 does not seem to be present

一，问题描述

在VMware里克隆出来的CentOS Linux。。

ifconfig...没有看到eth0.。然后重启网卡又报下面错误。

故障现象：

service network restart
Shutting down loopback insterface: [ OK ]
Bringing up loopback insterface: [ OK ]
Bringing up interface eth0: Device eth0 does not seem to be present,delaying initialization. [FAILED]

二，解决办法

1；

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23

首先，打开/etc/udev/rules.d/ 70 -persistent-net.rules内容如下面例子所示： # vi /etc/udev/rules.d/ 70 -persistent-net.rules # This file was automatically generated by the /lib/udev/write_net_rules # program, run by the persistent-net-generator.rules rules file. # # You can modify it,  as  long  as  you keep  each  rule on a single # line, and change only the value of the NAME= key. # PCI device  0x1022 : 0x2000  (pcnet32) SUBSYSTEM== "net" , ACTION== "add" , DRIVERS== "?*" , ATTR{address}==" 00 :0c: 29 :8f: 89 : 9 7 ", ATTR{type}==" 1 ", KERNEL==" eth* ", NAME=" eth0" # PCI device  0x1022 : 0x2000  (pcnet32) SUBSYSTEM== "net" , ACTION== "add" , DRIVERS== "?*" , ATTR{address}==" 00 :0c: 29 : 50 :bd: 1 7 ", ATTR{type}==" 1 ", KERNEL==" eth* ", NAME=" eth1" 记录下，eth1网卡的mac地址 00 :0c: 29 : 50 :bd: 17 接下来，打开/etc/sysconfig/network-scripts/ifcfg-eth0 # vi /etc/sysconfig/network-scripts/ifcfg-eth0 将 DEVICE= "eth0"   改成  DEVICE= "eth1"   , 将 HWADDR= "00:0c:29:8f:89:97"  改成上面的mac地址  HWADDR= "00:0c:29:50:bd:17" 最后，重启网络 # service network restart 或者 # /etc/init.d/network restart 正常了。