Robocopy 的返回值是一个位图，不同的返回值代表不同类型的错误或状态。例如，0×10 表示严重错误，可能由使用错误或权限不足引起；0×08 意味着复制过程中发生错误且超过重试限制。当使用 Hudson 或 CruiseControl 等软件时，非零返回值可能导致错误报告。解决方法是通过设置语句将错误级别重置为0，如 `%ERRORLEVEL% LEQ 7 set ERRORLEVEL=0`。参考链接提供了更多相关信息。
Robocopy Errorlevel Return Codes (found in robocopy.doc)
The return code from Robocopy is a bit map, defined as follows:
0×10 Serious error. Robocopy did not copy any files. This is either a usage error or an error due to insufficient access privileges on the source or destination directories.
0×08 Some files or directories could not be copied (copy errors occurred and the retry limit was exceeded). Check these errors further.
0×04 Some Mismatched files or directories were detected. Examine the output log. Housekeeping is probably necessary.
0×02 Some Extra files or directories were detected. Examine the output log. Some housekeeping may be needed.
0×01 One or more files were copied successfully (that is, new files have arrived).
0×00 No errors occurred, and no copying was done. The source and destination directory trees are compl
最低0.47元/天 解锁文章
扫一扫
735
被折叠的 条评论
为什么被折叠?
到【灌水乐园】发言
