RVDS2.2的invalid call from '~PRE8' 解决方法

There are two possible solutions to work-around this issue:

1) Rebuild all your objects/libraries using RVCT 2.x.
If you have any assembler files, you will need to:

i) check that all instructions preserve 8-byte stack alignment, and if necessary, correct them. （保留8字节堆栈对齐）
e.g. change: 将进栈寄存器数由奇数个改为偶数个
           STMFD sp!, {r0-r3, lr} ; push an odd number of registers
to
           STMFD sp!, {r0-r3, r12, lr} ; push an even number of registers
and:

ii) add the PRESERVE8 directive to the top of each assembler file. 将PRESERVE8保留字加在每个汇编文件前
e.g. change:
         AREA Init, CODE, READONLY
to:
         PRESERVE8
         AREA Init, CODE, READONLY

(the PRES8 attribute applies to the whole object, not just the code section).