HCIP第二次作业

一、拓扑搭建

 二、配置所有接口IP地址

配置接口IP，缺省指向ISP

 三、R1与R5之间的PAP认证

R5的PAP配置

R1的PAP认证

[R1-Serial4/0/0]ppp pap local-user wxj password cipher 123456

四、R2与R5之间的chap认证

R5的配置

[ISP-Serial1/0/1]ppp authentication-mode chap
R2的配置

[R2-Serial4/0/0]ppp chap user wxj
ppp chap password cipher 123456
五、R3与R5之间为HDLC封装

R5的配置

[ISP-Serial2/0/0]link-protocol hdlc 
R3的配置

[R3-Serial4/0/0]link-protocol hdlc
六、私用网段配置NAT

R1

[R1]acl 2000
[R1-acl-basic-2000]rule permit source 192.168.1.0 0.0.0.255
[R1-acl-basic-2000]int s4/0/0
[R1-Serial4/0/0]nat outbound 2000

R2

[R2]acl 2000
[R2-acl-basic-2000]rule permit source 192.168.2.0 0.0.0.255
[R2-acl-basic-2000]int s4/0/0
[R2-Serial4/0/0]nat outbound 2000

R3

[R3]acl 2000
[R3-acl-basic-2000]rule permit source 192.168.3.0 0.0.0.255
[R3-acl-basic-2000]int s4/0/0
[R3-Serial4/0/0]nat outbound 2000

R4

[R4]acl 2000
[R4-acl-basic-2000]rule permit source 192.168.1.0 0.0.0.255
[R4-acl-basic-2000]int g0/0/0
[R4-GigabitEthernet0/0/0]nat outbound 2000
结果

 七、R1与R4为点到点GRE

R1的配置

[R1]interface Tunnel 0/0/0   
[R1-Tunnel0/0/0]ip address 10.1.1.1 24    
[R1-Tunnel0/0/0]tunnel-protocol gre    
[R1-Tunnel0/0/0]source 15.1.1.1   
[R1-Tunnel0/0/0]destination 45.1.1.1
 

R4的配置

[R4]interface Tunnel 0/0/0  
[R4-Tunnel0/0/0]ip address 10.1.1.2 24   
[R4-Tunnel0/0/0]tunnel-protocol gre 
[R4-Tunnel0/0/0]source 45.1.1.1
[R4-Tunnel0/0/0]destination 15.1.1.1
 

结果：

八、R1/2/3构建MGRE

R1的配置

[R1]int Tunnel 0/0/1   
[R1-Tunnel0/0/1]ip address 10.1.2.1 24 
[R1-Tunnel0/0/1]tunnel-protocol gre p2mp
[R1-Tunnel0/0/1]source 15.1.1.1  
[R1-Tunnel0/0/1]nhrp entry multicast dynamic    
[R1-Tunnel0/0/1]nhrp network-id 100

R2的配置

[R2]interface Tunnel 0/0/1
[R2-Tunnel0/0/1]ip address 10.1.2.2 24
[R2-Tunnel0/0/1]tunnel-protocol gre p2mp   
[R2-Tunnel0/0/1]source Serial 4/0/0    
[R2-Tunnel0/0/1]nhrp network-id 100  
[R2-Tunnel0/0/1]nhrp entry 10.1.2.1 15.1.1.1 register 
 

R3的配置

[R3]interface Tunnel 0/0/1    
[R3-Tunnel0/0/1]ip address 10.1.2.3 24  
[R3-Tunnel0/0/1]tunnel-protocol gre p2mp    
[R3-Tunnel0/0/1]source Serial 4/0/0  
[R3-Tunnel0/0/1]nhrp network-id 100    
[R3-Tunnel0/0/1]nhrp entry 10.1.2.1 15.1.1.1 register 
结果：

 九、基于RIP全网可达

R1

[R1]rip 1
[R1-rip-1]version 2    
[R1-rip-1]undo summary    
[R1-rip-1]network 192.168.1.0
[R1-rip-1]network 10.0.0.0

[R1]interface Tunnel 0/0/1   
[R1-Tunnel0/0/1]undo rip split-horizon  关闭RIP的水平分割
 

R2

[R2]rip 1
[R2-rip-1]version 2    
[R2-rip-1]undo summary    
[R2-rip-1]network 192.168.2.0
[R2-rip-1]network 10.0.0.0

R3

[R3]rip 1
[R3-rip-1]version 2    
[R3-rip-1]undo summary    
[R3-rip-1]network 192.168.3.0
[R3-rip-1]network 10.0.0.0

R4

[R4]rip 1
[R4-rip-1]version 2    
[R4-rip-1]undo summary    
[R4-rip-1]network 192.168.4.0
[R4-rip-1]network 10.0.0.0

结果：