一.下载华为H3C Inode客户端:
下载地址:http://download.csdn.net/detail/majian_elvis/4170519
二.将压缩文件直接双击拖拽到你home目录
三.Ctrl+Alt+T打开终端.在终端里输入cd h3c802.1(tab补全)进入解压缩后的h3c目录
四.将C++库文件复制到/usr/lib
下载地址:http://download.csdn.net/detail/majian_elvis/4178981
假设文件下载到/home目录
sudo cp libstdc++-libc6.2-2.so.3 /usr/lib/
五.将linux1x.pre.ps renew.ps三个文件加上可执行权限,命令如下
sudo chmod a+x linux1x pre.ps renew.ps
六.执行pre.ps安装软件
sudo ./pre.ps
七.配置客户端
sudo linux1x -c
终端显示如下:请自行配置,根据自己学校情况分析
configure 802.1X network connection argumente
Current configuration is:
The way to initialize 802.1X authentication.......:multicast
Send all packets by multicast.....................:Y
Refresh IP address after connecting...............:Y
Save message and package to log...................:Y
Continue to configure your network connection arguments?(Y/N)
y
There are two ways to initialize 802.1X authentication:
1. Trap by broadcast.
2. Trap by multicast.
Please choose the way to initialize the 802.1X authentication :
2
Send all packets by multicast? (Y/N):
y
Refresh your IP address after connecting? (Y/N):
n
Save message and package to log?(Y/N):
n
Configuration has finished, do you want to save it?(Y/N)
y
Save configuration sucessfully!
八.开始认证在终端里输入:
sudo linux1x -d 第一次需要选择使用哪个有线连接,选eth0就OK了,终端显示如下:
Please enter your user name (less than 128 characters):********
Please enter your password (less than 64 characters):
Please choose a network adapter:
1. eth0
2. wlan0
Enter the number of your choice (1-2[1]): 1
start 802.1X authentication
device check
server check
pass authentication
OK,乖乖,终于可以上网了,不错不错,
注意:一般开机,ubuntu会自动进行认证连接上网,如果出现掉线的情况(校园网的招牌能耐啊),再打开终端输入
sudo Linux1x -d
重新认证一次就OK了
本文转自http://wangji.blog.51cto.com/809072/220214 在此鸣谢作者.