#service tgtd start
The tgtd service is provided by the package: scsi-target-utils.x86_64
2.Define an iSCSI target name: (for example)
# tgtadm --lld iscsi --op new --mode target --tid=1 --targetname iqn.2001-04.com.example:storage.disk1.amiens.sys1.xyz
3.To view the currect configuration:
# tgtadm --lld iscsi --op show --mode target
For example, here we create a 10G file as the block device:
# dd if=/dev/zero of=/disk1 bs=1M count=10240
4.Add it as a logical unit to the target:
# tgtadm --lld iscsi --op new --mode logicalunit --tid 1 --lun 1 -b /disk1
5.Enable the target to accept any initiators:
# tgtadm --lld iscsi --op bind --mode target --tid 1 -I ALL
6.View the current configuration again:
# tgtadm --lld iscsi --op show --mode target
7.Ensure TCP port 3260 can be accessed from remote host.
8.Start from Red Hat Enterprise Linux 5.3, tgt-admin and /etc/tgt/targets.conf can be used for make the setup persistent over reboot:
# tgt-admin --dump > /etc/tgt/targets.conf
# chkconfig tgtd on
9.In releases prior to Red Hat Enterprise Linux 5.3, you have to put the "tgtadm" commands into /etc/rc.local and enable the tgtd service:
echo >> /etc/rc.local <<EOF
tgtadm --lld iscsi --op new --mode target --tid=1 --targetname iqn.2001-04.com.example:storage.disk1.amiens.sys1.xyz
tgtadm --lld iscsi --op new --mode logicalunit --tid 1 --lun 1 -b /disk1
tgtadm --lld iscsi --op bind --mode target --tid 1 -I ALL
# chkconfig tgtd on
<<How to configure the iscsi-initiator>>
1.First install the iscsi-initiator-utils package
#yum install iscsi-initiator-utils
2.Second start the iscsid service and enable it to start when the system boots:
#service iscsid start
#chkconfig iscsid on
3.Then obtain a listing of available targets from a given host (please note that ipaddress listed below must be replaced with the resolvable hostname or ip address of the system providing the port if different than default):
#iscsiadm -m discovery -t sendtargets -p ipaddress
#iscsiadm --mode node --targetname dhcp-9-242.nay.redhat.com:rhel6u4 --portal 10.66.9.242:3260 --login
4.Finally, use the following command to login to the available target (again, replace targetname with one from the output of the previous command and replace ipaddress below with that of the target system):
#iscsiadm -m node -T targetname -p ipaddress -l
This will enable the target to be accessed upon reboots and it stores it in a node database found in /var/lib/iscsi that is more thoroughly described in the /usr/share/doc/iscsi-initiator-utils-VERSION/README file.
For a more verbose listing of possible options for the iscsiadm command in Red Hat Enterprise Linux 5 refer to the manual page using:
#man iscsiadm
############################################
#delete lun
# tgtadm --lld iscsi --mode logicalunit --op delete --tid 1 --lun 1