stm32f407单片机底层应用程序_usart2

usart2.c

#include "usart2.h"


void My_USART2_Init(USART_TypeDef* USARTx,u32 bound)
{
	GPIO_InitTypeDef     GPIO_InitStructure;
	USART_InitTypeDef   USART_InitStructure;
	

	RCC_APB1PeriphClockCmd(RCC_APB1Periph_USART2,ENABLE); 	
	RCC_AHB1PeriphClockCmd(RCC_AHB1Periph_GPIOA,ENABLE);


	GPIO_PinAFConfig(GPIOA, GPIO_PinSource2, GPIO_AF_USART2);
	GPIO_PinAFConfig(GPIOA, GPIO_PinSource3, GPIO_AF_USART2); 
	
		
	GPIO_InitStructure.GPIO_Pin = GPIO_Pin_2|GPIO_Pin_3; 
	GPIO_InitStructure.GPIO_Mode = GPIO_Mode_AF;
	GPIO_InitStructure.GPIO_OType = GPIO_OType_PP;
	GPIO_InitStructure.GPIO_PuPd = GPIO_PuPd_UP;
	GPIO_InitStructure.GPIO_Speed = GPIO_Speed_100MHz;
	GPIO_Init(GPIOA,&GPIO_InitStructure);
			
	//USART
	USART_InitStructure.USART_BaudRate = bound;
	USART_InitStructure.USART_WordLength = USART_WordLength_8b;
	USART_InitStructure.USART_StopBits = USART_StopBits_1;
	USART_InitStructure.USART_Parity = USART_Parity_No;
	USART_InitStructure.USART_HardwareFlowControl = USART_HardwareFlowControl_None;
	USART_InitStructure.USART_Mode =  USART_Mode_Rx | USART_Mode_Tx;	
	USART_Init(USARTx,&USART_InitStructure);
	
	
	
		
	USART_DMACmd(USARTx, USART_DMAReq_Rx, ENABLE);	
	USART_DMACmd(USARTx, USART_DMAReq_Tx, ENABLE);	
	USART_ITConfig(USARTx, USART_IT_IDLE, ENABLE); 
	
	USART_Cmd(USARTx,ENABLE);	

}

usart2.h

#ifndef  __USART2_H
#define  __USART2_H
#include "sys.h"


void My_USART2_Init(USART_TypeDef* USARTx,u32 bound);


#endif