1.芯片图
2.Frequency range = 425–525 MHz
可覆盖425-525MHz频段
3.The Si4438 operates as a time division duplexing (TDD) transceiver where the device alternately transmits and receives data packets
双工收发,交替发送和接收数据包。
4.receiver do not operate at the same time
发送和收不能同时工作。
5.The demodulated signal is output to the system MCU through a programmable GPIO or via the standard SPI bus by reading the 64-byte RX FIFO
通过可编程的 GPIO 或通过解读 64 字节 RXFIFO 的标准 SPI 总线,已调制的信号可被输出到 MCU 系统。
如图所示4438与主机MCU通信方式
6.The Si4438 family supports TX/RX switch control, and antenna diversity switch control to extend the link range and improve performance
支持 TX/RX 开关控制和天线分集开关控制以扩展链路范围和提高性能。
7.SPI接口
4线与主机MCU通讯:SCLK、SDI、SDO、nSEL
8.SPI写过程
1)The nSEL pin should go low to initiate the SPI command。
拉低nSEL启动SPI命令
2)The first byte of SDI data will be one of the firmware commands followed by n bytes of parameter data
which will be variable depending on the specific command