Linux下启动httpd服务提示not bind to address

这几天在装Apache httpd服务后，启动httpd服务，报错如下：
Starting httpd: httpd: Could not reliably determine the server's fully qualified domain name, using 0.0.0.0 for ServerName
(13)Permission denied: make_sock: could not bind to address [::]:88
(13)Permission denied: make_sock: could not bind to address 0.0.0.0:88
no listening sockets available, shutting down
Unable to open logs             [FAILED]

发现是SELinux在作怪，查看SElinux使用状态
#getenforce
Enforcing
SElinux未禁用。
1、临时禁用SELinux：# setenforce 0这样重启服务器之后，还是会启动SELinux；
备注：setenforce 1 临时启用SELinux

2、永久禁用：打开服务器上的SELinux配置文件，默认为：/etc/selinux/config（还有/etc/sysconfig/selinux），内容如下：# This file controls the state of SELinux on the system.# SELINUX= can take one of these three values:#       enforcing - SELinux security policy is enforced.#       permissive - SELinux prints warnings instead of enforcing.#       disabled - SELinux is fully disabled.SELINUX=enforcing# SELINUXTYPE= type of policy in use. Possible values are:#       targeted - Only targeted network daemons are protected.#       strict - Full SELinux protection.SELINUXTYPE=targeted将上面的SELINUX=enforcing 改为：SELINUX=disable  禁用SeLinux

然后启动httpd服务：
service httpd start
Starting httpd: httpd: Could not reliably determine the server's fully qualified domain name, using 0.0.0.0 for ServerName
                                                           [  OK  ]
 
 
转载原文：https://blog.csdn.net/rachel_luo/article/details/22311717