FCC-5G基站测试标准解读-最大输出功率（Maximum Output Power）

爱学习的man

于 2023-02-03 09:57:41 发布

阅读量615

点赞数 1

分类专栏：学习总结文章标签：模块测试 Powered by 金山文档

本文链接：https://blog.csdn.net/qq_20799821/article/details/128861401

版权

学习总结专栏收录该内容

35 篇文章 2 订阅

订阅专栏

文章详细描述了按照FCCCFR47Part2和Part27以及RSS-199的规定，对设备在最大功率和适当调制下进行测试的方法。在MIMO模式下，使用测量和求和方法测试所有天线的输出功率，并按线性功率单位数学上相加。输出功率限值基于EIRP，且与发射带宽相关。

摘要由CSDN通过智能技术生成

- 参考标准

FCC CFR 47 Part 2, Clause2.1046

FCC CFR 47 Part 27, Clause27.50(h)

RSS-199, Clause 4.4

- 测试方法

During the process oftesting, the EUT was configured to transmit on maximum power and propermodulation. The transmitter power shall be measured in terms of aroot-mean-square (RMS) average value. In case of the EUT was configured to MIMOmode, since the EUT transmits on all antennas simultaneously in the samefrequency range, using the Measure-and-Sum approach, the output power at allantennas were tested, and the total output power were then summedmathematically in linear power units according to FCC KDB 662911 D01.

- 限值

Output Power:

(EIRP) 1640 W or 62.15 dBmfor emission bandwidth ≤ 1MHz 1640 W/MHz or62.15 dBm/MHz for emission bandwidth > 1MHz

33 dBW + 10log(X/Y) dBW, where X is the actual channelwidth in MHz and Y is either6 MHz if prior to transition or the stationis in the MBS following transition or 5.5 MHz if the station is in the LBS and UBS following transition