3GPP-NR Band46标准定义频点和信道（3GPP V17.7.0 (2022-12)）

Reference test frequencies for NR operating band n46

Table 4.3.1.1.1.46-1: Test frequencies for NRoperating band n46 and SCS 15 kHz (Note 3)

CBW [MHz]	carrierBandwidth [PRBs]	Range		Carrier centre [MHz]	Carrier centre [ARFCN] Note 4	point A [MHz]	absoluteFrequencyPointA [ARFCN]	offsetToCarrier [Carrier PRBs]	SS block SCS [kHz]	GSCN	absoluteFrequencySSB [ARFCN]		Offset Carrier CORESET#0 [RBs] Note 2	CORESET#0 Index (Offset [RBs]) Note 1	offsetToPointA (SIB1) [PRBs] Note 1
10	52	Downlink	Low	5730	782000	5725.32	781688	0	30	-	781928	31	-	-	-
		&	Mid							-
		Uplink	High	5830.02	788668	5734.62	782308	504		-	788596	31	-	-	-
20	106	Downlink	Low	5160	744000	5150.46	743364	0	30	-	743604	31	-	-	-
		&	Mid	5479.98	765332	5452.08	763472	102		-	764936	31	-	-	-
		Uplink	High	5905.02	793668	5804.76	786984	504		-	793272	31	-	-	-
40	216	Downlink	Low	5170.02	744668	5150.58	743372	0	30	-	743612	31	-	-	-
		&	Mid	5509.98	767332	5472.18	764812	102		-	766276	31	-	-	-
		Uplink	High	5895	793000	5784.84	785656	504		-	791944	31	-	-	-
Note 1: The CORESET#0 Index and the associated CORESET#0 Offset refers to Table 13-3 in TS 38.213 [22]. The value of CORESET#0 Index is signalled in controlResourceSetZero (pdcch-ConfigSIB1) in the MIB. The offsetToPointA IE is expressed in units of resource blocks assuming 15 kHz subcarrier spacing for FR1 and 60 kHz subcarrier spacing for FR2. Note 2: The parameter Offset Carrier CORESET#0 specifies the offset from the lowest subcarrier of the carrier and the lowest subcarrier of CORESET#0. It corresponds to the parameter ΔFOffsetCORESET-0-Carrier in Annex C expressed in number of common RBs. Note 3: NR band n46 with SCS =15 kHz is restricted for operation when carrier is configured as an SCell part of a DC or CA configuration. As the bandwidth is limited to SCell then absence of CORESET#0 is indicated in the MIB by setting =31, controlResourceSetZero=0 and searchSpaceZero = 0 (TS 38.213 [22], clause 13). Note 4: The selection of Low, Mid and High test frequencies are restricted to the limited allowed ARFCN values as specified in TS 38.101 [7], Table 5.4.2.3-2.

Table 4.3.1.1.1.46-2: Test frequencies for NRoperating band n46 and SCS 30 kHz

CBW [MHz]	carrierBandwidth [PRBs]	Range		Carrier centre [MHz]	Carrier centre [ARFCN] Note 4	point A [MHz]	absoluteFrequencyPointA [ARFCN]	offsetToCarrier [Carrier PRBs]	SS block SCS [kHz]	GSCN	absoluteFrequencySSB [ARFCN]		Offset Carrier CORESET#0 [RBs] Note 2	CORESET#0 Index (Offset [RBs]) Note 1	offsetToPointA (SIB1) [PRBs] Note 1
10	24	Downlink	Low	5730	782000	5725.68	781712	0	30	-	781952	31	-	-	-
Note 3		&	Mid
		Uplink	High	5830.02	788668	5644.26	776284	504		-	788620	31	-	-	-
20	51	Downlink	Low	5160	744000	5150.82	743388	0	30	8996	743712	12	0	3 (3)	6
		&	Mid	5479.98	765332	5434.08	762272	102		9218	765024	16	0	2 (2)	208
		Uplink	High	5905.02	793668	5714.4	780960	504		9513	793344	0	0	2 (2)	1012
40	106	Downlink	Low	5170.02	744668	5150.94	743396	0	30	8996	743712	4	0	3 (3)	6
		&	Mid	5509.98	767332	5454.18	763612	102		9232	766368	20	0	2 (2)	208
		Uplink	High	5895	793000	5694.48	779632	504		9499	792000	8	0	1 (1)	1010
60	162	Downlink	Low	5200.02	746668 Note 5	5170.86	744724	0	30	9010	745056	20	0	3 (3)	6
		(Note 3)	Mid	5500.02	766668	5434.14	762276	102		9218	765024	12	0	2 (2)	208
		(Note 3)	High	5884.98	792332	5674.38	778292	504		9485	790656	4	0	1 (1)	1010
80	217	Downlink	Low	5190	746000	5150.94	743396	0	30	8996	743712	4	0	3 (3)	6
		(Note 3)	Mid	5500.02	766668	5424.24	761616	102		9218	765024	0	27	3 (3)	264
		(Note 3)	High	5875.02	791668	5654.52	776968	504		9472	789408	8	1	3 (3)	1016
Note 1: The CORESET#0 Index and the associated CORESET#0 Offset refers to Table 13-4 in TS 38.213 [22]. The value of CORESET#0 Index is signalled in controlResourceSetZero (pdcch-ConfigSIB1) in the MIB. The offsetToPointA IE is expressed in units of resource blocks assuming 15 kHz subcarrier spacing for FR1 and 60 kHz subcarrier spacing for FR2. Note 2: The parameter Offset Carrier CORESET#0 specifies the offset from the lowest subcarrier of the carrier and the lowest subcarrier of CORESET#0. It corresponds to the parameter ΔFOffsetCORESET-0-Carrierin Annex C expressed in number of common RBs. Note 3: For this bandwidth, the minimum requirements are restricted to operation when carrier is configured as an SCell part of a DC or CA configuration. As the bandwidth is limited to SCell then absence of CORESET#0 is indicated in the MIB by setting =31, controlResourceSetZero=0 and searchSpaceZero = 0 (TS 38.213 [22], clause 13). Note 4: The selection of Low, Mid and High test frequencies are restricted to the limited allowed ARFCN values as specified in TS 38.101 [7], Table 5.4.2.3-2. Note 5: The next lowest allowed ARFCN values has been selected as the lowest ARFCN value in TS 38.101 [7], Table 5.4.2.3-2 for CBW=60 MHz will cause the required guardband to exceed the bands lower edge.

Table 4.3.1.1.1.46-3: Test frequencies for NRoperating band n46 and SCS 60 kHz without CORESET#0 (Note 1)

CBW [MHz]	carrierBandwidth [PRBs]	Range		Carrier centre [MHz]	Carrier centre [ARFCN] Note 2	point A [MHz]	absoluteFrequencyPointA [ARFCN]	offsetToCarrier [PRBs]	SS block SCS [kHz]	GSCN	absoluteFrequencySSB [ARFCN]
10	11	Downlink	Low	5730	782000	5726.04	781736	0	30	-	781976
		&	Mid
		Uplink	High	5830.02	788668	5463.18	764212	504		-	788644
20	24	Downlink	Low	5160	744000	5151.36	743424	0	30	-	743664
		&	Mid	5479.98	765332	5397.9	759860	102		-	764996
		Uplink	High	5905.02	793668	5533.5	768900	504		-	793332
40	51	Downlink	Low	5170.02	744668	5151.66	743444	0	30	-	743684
		&	Mid	5509.98	767332	5418.18	761212	102		-	766348
		Uplink	High	5895	793000	5513.76	767584	504		-	792016
60	79	Downlink	Low	5179.98	745332	5151.54	743436	0	30	-	743676
		&	Mid	5500.02	766668	5398.14	759876	102		-	765012
		Uplink	High	5884.98	792332	5493.66	766244	504		-	790676
80	107	Downlink	Low	5190	746000	5151.48	743432	0	30	-	743672
		&	Mid	5500.02	766668	5388.06	759204	102		-	764340
		Uplink	High	5875.02	791668	5473.62	764908	504		-	789340
Note 1: FR1 carrier without CORESET#0 is indicated in the MIB by setting =31, controlResourceSetZero=0 and searchSpaceZero = 0 (TS 38.213 [22], clause 13). Note 2: The selection of Low, Mid and High test frequencies are restricted to the limited allowed ARFCN values as specified in TS 38.101 [7], Table 5.4.2.3-2.