Brocade博科交换机忘记密码passwd重置操作步骤

1.用串口线连接博科FC交换机设备

2.重新启动博科FC交换机

3.当终端软件显示下面内容时，按ESC键

Checking system RAM - press any key tostop test

Checking memory address: 00100000

System RAM test terminated by keyboard

set_bootstatus: BS_LOAD_OS, platform_idx= 6

Hit ESC to stop autoboot: 0

4.按ESC键后进入以下界面，选择3

5.注意

如果提示您输入一个新的启动密码,确保它是至少8个字符在长度。不要选择这个选项,除非专业人员。

6.输入

setenv OSLoadOptions "single" 

改变用户模式

7.输入

printenv

来验证变化

查看printenc输出选项中，OSLoadOptions选项的值是single

8.如果输出无误，则输入

saveenv

来保存配置

9.输入

boot

命令进入单用户模式（输入下面红色字体的命令）

 Enter the boot command withno parameters to bring up the device in single-user mode:

=> boot

Map file at LBA sector 0x17da68

## Booting image at 00400000 ...

(output truncated) mount -o remount,rw /

Enterthe mount command with the following parameters to remount the root partitionas read/write capable:

sh-2.04# mount -o remount,rw /

EXT3 FS on hda1, internal journal

Mountthe secondary partition.

If the previous command returns hda2, thenuse hda1 in this command. If the previous command returns hda 1, use hda2.

sh-2.04# mount /dev/hda2 /mnt

kjournald starting. Commit interval 5 seconds

EXT3 FS on hda2, internal journal

EXT3-fs: mounted filesystem with ordered data mode.

Enterthe passwddefault command to reset all passwords to default values as follows:

sh-2.04# /sbin/passwddefault

All account passwords have been successfully set to factory default.

If additional user accounts existed, they are deleted. Only the defaultaccounts and passwords remain.

Resetthe OSLoadOptions to “quiet;quiet”,Password recovery using the Boot PROM interface

sh-2.04# bootenv OSLoadOptions ”quiet;quiet”

Rebootthe switch by using the reboot –f command.

sh-2.04# reboot -f

待设备重启后，即完成密码重置，输入默认密码登录即可