ensp链路聚合

二层链路聚合配置

[Huawei]int eth-trunk 1     //创建聚合链路
[Huawei]q
[Huawei]int g0/0/1
[Huawei-GigabitEthernet0/0/1]eth-trunk 1     //划分端口
[Huawei]q
[Huawei]int g0/0/2
[Huawei-GigabitEthernet0/0/2]eth-trunk 1
[Huawei-GigabitEthernet0/0/2]                            
[Huawei]dis int eth-trunk 1
Eth-Trunk1 current state : UP
Line protocol current state : UP
Description:
Switch Port, PVID :    1, Hash arithmetic : According to SIP-XOR-DIP,Maximal BW:
 2G, Current BW: 2G, The Maximum Frame Length is 9216
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is 4c1f-cc32-6785
Current system time: 2020-08-14 16:35:12-08:00
    Input bandwidth utilization  :    0%

    Output bandwidth utilization :    0%
-----------------------------------------------------
PortName                      Status      Weight
-----------------------------------------------------
GigabitEthernet0/0/1          UP          1
GigabitEthernet0/0/2          UP          1
-----------------------------------------------------
The Number of Ports in Trunk : 2
The Number of UP Ports in Trunk : 2

三层链路聚合配置

[Huawei]int Eth-Trunk 1
[Huawei-Eth-Trunk1]undo portswitch
[Huawei-Eth-Trunk1]q
[Huawei]int g0/0/0
[Huawei-GigabitEthernet0/0/0]eth-trunk 1
[Huawei-GigabitEthernet0/0/0]q
[Huawei]int g0/0/1
[Huawei-GigabitEthernet0/0/1]eth-trunk 1
[Huawei-GigabitEthernet0/0/1]q
[Huawei]int Eth-Trunk 1
[Huawei-Eth-Trunk1]ip address 192.168.1.1 24
[Huawei-Eth-Trunk1]q
[Huawei]dis eth-trunk 1
Eth-Trunk1's state information is:
WorkingMode: NORMAL         Hash arithmetic: According to SIP-XOR-DIP         
Least Active-linknumber: 1  Max Bandwidth-affected-linknumber: 8              
Operate status: up          Number Of Up Port In Trunk: 2                     
--------------------------------------------------------------------------------
PortName                      Status      Weight 
GigabitEthernet0/0/0          Up          1      
GigabitEthernet0/0/1          Up          1      

*删除链路聚合组中删除成员接口
在接口视图下执行undo eth-trunk命令。
在Eth-Trunk视图下执行undo trunkport interface-type { interface-number1 [ to interface-number2 ] } &<1-8>命令